登录
首页 » 嵌入式系统 » 用c编写的基于ARM的max1246的驱动程序源码和应用示例。

用c编写的基于ARM的max1246的驱动程序源码和应用示例。

于 2022-01-26 发布 文件大小:4.51 kB
0 252
下载积分: 2 下载次数: 1

代码说明:

用c编写的基于ARM的max1246的驱动程序源码和应用示例。-c prepared with the ARM-based max1246 driver source code and application examples.

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • SPI STM32F4
    这是stm32f4xx的,我刚刚完成了SPI通信。这很简单,但可以帮助新手学习stm32f4xx。干杯!
    2022-02-05 14:12:38下载
    积分:1
  • 基于s3C2410的源代码 在linux操作下实现
    基于s3C2410的源代码 在linux操作系统下实现-S3C2410-based source code in the linux operating system to achieve
    2022-10-30 23:55:02下载
    积分:1
  • 汽车PKE工程 密钥转发器程序 通过车厂认证的哦
    The PCF7991AT is a fully integrated Advanced Basestation IC, ABIC, designed for car immobilizer systems providing read and write access to an identification transponder. The device is intended for use with the NXP transponder family (PCF79xx) as well as other transponder types operating at 125 kHz and employing ASK, Amplitude Shift Keying for write and AM/PM for the read operation. The receiver characteristics (amplifier gain,filter cutoff frequencies) can be optimized to system and transponder requirements. The PCF7991AT IC is designed for easy integration into immobilizer read/write and read-only systems featuring a high degree of integration and very low external component count. The device integrates a powerful antenna driver/modulator, a low-noise adaptive sampling time demodulator, programmable filters/amplifier and digitizer, required to design high-performance basestations. A three wire microcontroller interface is provided for programming the PCF7991AT as well as for th
    2023-01-18 14:55:03下载
    积分:1
  • 电子调速器源代码
    用于无感无刷直流电机调速的电子调速器驱动程序。基于ATmega8单片机,使用C语言开发,此版本是基于MK电调程序最新版本0.42开发。源程序分为电调上电自检,电机启动,反电动势过零检测,IIC、PPM、串口信号接收,电流测试,电调地址设定等功能。是一个完善可以的电调驱动程序。
    2022-06-03 14:11:02下载
    积分:1
  • Moto E2的键盘软锁v2源代码,使用qt,(0.02版sdk) 有附加说明,在linux下可以正常查看,在windows下可能会有部分乱码...
    Moto E2的键盘软锁v2源代码,使用qt,(0.02版sdk) 有附加说明,在linux下可以正常查看,在windows下可能会有部分乱码-err
    2022-02-07 16:34:02下载
    积分:1
  • linux中的usb热拔插脚本,可以实现u盘的热拔插功能
    嵌入式linux中的usb热拔插脚本,可以实现u盘的热拔插功能-Embedded linux in usb hot plug script, you can realize u disk hot-swap function
    2022-07-06 21:28:15下载
    积分:1
  • sd卡的高速读写程序,sd模(4数据线),是普通spi模的约6倍,以及完全的sd卡的data sheet...
    sd卡的高速读写程序,sd模式(4数据线),是普通spi模式的约6倍,以及完全的sd卡的data sheet-sd-card reader procedures, sd model (four data lines), is the general pattern of about 20 six times. and full sd card data sheet
    2023-02-22 13:15:03下载
    积分:1
  • msp430g2553 为外围设备的驱动程序
    有 msp43G2553 的 lib。它包括 1 周边 Basic_config 2 外围 I2C 3 周边液晶屏 4 外围 SPI 5 周边城市轨道交通
    2023-06-10 16:10:03下载
    积分:1
  • 利用LABVIEW8.6写的tcpip协议的客户端程序
    利用LABVIEW8.6写的tcpip协议的客户端程序-Use LABVIEW8.6 written agreement tcpip client program
    2023-06-10 02:30:03下载
    积分:1
  • 单片机mk7a11bp数据表,是一个8位RISC高性能单片机。我..
    Datasheet for MCU MK7A11BP, is an 8 bit RISC high performance microcontroller. It is equipped with 1Kx14bits OTP(One Time Programmable) ROM, 32 Bytes RAM, Timer/Counter, Interrupt, LVR(Low Voltage Reset)and I/O ports in a single chip.
    2022-07-18 11:37:11下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载