吉时利 6517A 控制 Labview 六库

以labview为平台对《自控制原理》的各个实验进行了仿真(Taking LabVIEW as the platform, the experiment of the principle of self control is simulated)

Labview中，将DBL类型的数据转换为U8类型的数据程序。可用于VISA，TCP/IP通信等案例中。

实现GPIB设备识别列表显示，输出选择的GPIB设备信息，将波形图发送到GPIB接口的示波器设备并显示出来。(For device identification display list GPIB, GPIB output selection device information will be sent to the waveform of the oscilloscope GPIB interface device and displayed.)

用于振动信号的采集，LABVIEW程序，用于齿轮箱等机械设备的振动故障诊断。(For vibration signal acquisition, LABVIEW program for vibration fault diagnosis of gearboxes and other mechanical equipment.)

说明：  labview串口接收、发送（分开）程序以及总通信程序(LabVIEW serial port receive, send (separate) program and general communication program)

labview 的循环创建数组，并存入电脑excel(The LabVIEW loop creates an array and stores it in the computer Excel)

基于labview的平台，构建了多通道虚拟示波器。(Based on LabVIEW platform, a multi-channel virtual oscilloscope is constructed.)

用labview开发的服务器端tcp/ip通讯程序,可用于工业控制中的网络通讯部分(Using LabVIEW to develop server-side tcp/ip communication procedures, can be used for industrial control of the network communication part)

不需要导入DBC即可实现使用NI XNET平台发送CAN报文，修改报文属性，接收报文(Without importing DBC, you can use the NI XNET platform to send CAN messages, modify the message properties, and receive messages.)

labview中对串口进行操作，注意：这不是普通的操作方法，而是使用队列的方法，避免了数据乱串的象限。(labview visa queue control)