all picture use for woman

这是一个在proteus软件上仿真的例子。对学习proteus这个软件具有很好的了解。-This is a software simulation in proteus example. Proteus in learning this software has a very good understanding.

了一些时间了解 TFT LCD 的结构以及工作原理，并整理下来加深自己的理解以及提供大家参考，这只是-err

51单片机的上网实现,上网程序清单C51-浮点运算功能-51 MCU web, Internet list of procedures C51-floating point performance

这是msp430与1335的接口控制程序，控制320*240的液晶显示驱动。-This is the MSP430 with the 1335 interface control procedures, control 320* 240 LCD display driver.

双STF16360EN驱动点阵VFD显示-Dual-drive dot matrix VFD display STF16360EN

cw环境下例子程！ DS18B20实验 用户成功安装好CW6.0后，双击每个实验文件夹下的.mcp文件即可。 注：用户如果安装其他CW软件，一定要确保.mcp文件打开方式为CW6.0.-cw example environment-way! DS18B20 experimental CW6.0 successfully installed, double-click each folder under the experiment. Mcp files. Note: If users install additional software CW, we must ensure that. Mcp file open for CW6.0.

关于嵌入式PS2键盘的原理图，基于51单片机的工控键盘。很实用，包括程序，基于Keil的软件程序-On the embedded PS2 keyboard schematics, single-chip microcomputer-based industrial control keyboard 51. Very practical, including the procedures, the software program based on the Keil

TONG GUO TONG GUOT-Nov. 81st Nov. GUOT

红外遥控接收 ORG 0000H LJMP START 转入主程序 ORG 0010H START: MAIN: JNB P2.2,IR LJMP MAIN 以下为进入P3.2脚外部中断子程序，也就是解码程序 IR: MOV R6,#9 SB: ACALL DELAY882 调用882微秒延时子程序 JB P2.2,EXIT 延时882微秒后判断P3.2脚是否出现高电平如果有就退出解码程序 DJNZ R6, SB 重复10次，目的是检测在8820微秒内如果出现高电-infrared remote control receiver ORG 0000H LJMP START into main program ORG 0010H START : MAIN : JNB P2.2, IR LJMP MAIN below to enter P3.2 foot external interrupt subroutine, which is decoding procedures IR : MOV R6, SB# 9 : Calling ACALL DELAY882 882 microsecond delay subroutine JB P2.2, EXIT 882 microsecond delay after the judgment whether there P3.2 feet to I quit if decoding procedures DJNZ R6, SB repeated 10 times, the purpose is to test if within 8,820 microsecond high

基于单片机8051的嵌入式开发指南主要是rty51和UCOS操作系统的开发.-Based on the 8051 single-chip embedded development guide primarily uCOS rty51 and operating system development.