寻迹机器人设计开发环境为ICC,可以编译成汇编,直接下栽到嵌入式avr单片机进行控制...

C:CypressUSBExamplesFX2重要的实验程序cypress官方提供模版ezusb-C: CypressUSBExamplesFX2 important experimental procedures cypress official template ezusb

ADC0809数据采集系统 ADC0809数据采集系统-ADC0809

我们设计的火灾报警器，基本上满足要求，大家可以参考-We design fire alarm, and basically meet the requirements of everyone can refer to

max7219控制的源程序，经过测试，给需要者

利用NRF9e5芯片编写的C51源代码，可实现点到点无线通信接收部分。-NRF9E5 chips prepared using C51 source code, can be achieved to receive part of point-to-point wireless communications.

c8051f340 USB传输 固件驱动， c8051f340 USB传输 固件驱动，-transmission c8051f340 USB drive firmware, c8051f340 USB transmission firmware-driven,

240X160触摸屏控制源程序,适用于液晶型号为8X10D-240x160 touch screen to control the source code, apply to LCD models 8X10D

16位10进制加法程序，KEIL51编写，适合单片机 -16 10 hex addition procedures, KEIL51 preparation for SCM

keilc + proteus 并行口设计指示灯实验 要求：掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.

指纹通讯模块程序，该模块以ATMEL公司的89s52为单片机与指纹模块进行数据通讯，以面向门禁或考勤等应用-Fingerprint procedures for communication module, the module to ATMEL Corporation 89s52 for single-chip modules and fingerprint data communication-oriented applications such as access control or attendance