本文从理论上推导出CRC 算法实现原理，给出三种分别适应不同计算机或微控制器硬件环境的C 语言程序。读者更能根据本算法原理，用不同的语言编写出独特风格更加实用的

MPU6050模块为主的整套用具和c，51，代码 可以用来开发遥控机器人 飞机 鼠标 航拍等  

改进的胶印机控制程序，西门子PLC可编程控制器源码-Improved Offset control procedures, Siemens PLC programmable controller source

IAR编写的MSP430的ADC-LCD-IAR s MSP430 prepared ADC-LCD

4*4键盘C51单片机程序.本程序已经调试通过，4*4键盘接P1口数据从P2的8个发光二极管来表示-4* 4 keyboard C51 Singlechip procedures. This procedure has been debugging through, 4* 4 keyboard access data from the P2 port P1 of the eight light-emitting diodes to indicate the

通过编程，实现FL2440 开发板按键 S0 和 S2 的中断实验，串口输出。

NX25P40存储器测试程序！NX25P40与W25X40可兼容。-Memory testing procedures NX25P40! W25X40 compatible with NX25P40.

arm-linux交叉编译环境的建立

1．在发送端通过一个编码系统对待传数据预先编码，在接收端将传来的数据进行译码（复原）。对于双工信道（即可以双向传输信息的通道），每端都需要一个完整的编/译 码系统。 2．本程序的目的是大大提高通信的信道利用率，缩短信息传输时间，降低传输成本。 -1. In the transmitter through a coding system for pre-treatment data-coding the receiving end of data from the decoding (recovery). For dual-channel (two-way transmission of information can access), each side needs a complete encoding/decoding system. 2. The procedures are designed to greatly enhance the communication channel utilization, reduced transmission time, and lower transmission costs.

BK2411资料难找，BK2411使用起来跟24L01基本一样，硬件上基本兼容，软件上只是开始要对BK2存储器进行初始化，花掉很长一段代码。初始化完成后，操作就跟24L01基本一样了-BK2411 information hard to find, BK2411 to use essentially the same with the 24L01, the hardware basically compatible, software is only the beginning of the BK2 memory to initialize, to spend a very long piece of code. Initialization is complete, operate basically the same as the Jiugen 24L01

嵌入式LINUX I/O口驱动,YC2410-SBC T2 平台-Embedded LINUX I/O port drivers, YC2410-SBC T2 platform