一个采用C8051F020芯片实现的流量计控制系统源代码，包括了对C8051F020内部AD和DA的编程、共12个LED（采用74HC195)的编码驱动编程等。...

用DS18B20测温传感器和MCS――51单片机，实现实时温度检测。-DS18B20 temperature sensor and with MCS- 51 Single-chip, real-time temperature detection.

用C51实现的拼音输入法,这是改写的网友 embuffalo、独步上载在www.21ic.com自由发布区的由张凯原作的51上的拼音输入法程序。 原作使用了一个二维数组用以查表，我认为这样比较的浪费空间，而且每个字表的索引地址要手工输入，效率不高。所以我用结构体将其改写了一下。就是大家现在看到的这个。 因为代码比较的大，共有6,000多汉字，这样就得要12,000 byte来存放GB内码，所以也是没办法的 :-( 编译结果约为3000h,因为大部分是索引表，代码优化几乎无效。 在Keil C里仿真芯片选用的是华邦的W77E58，它有32k ROM, 256B on-chip RAM, 1K on-chip SRAM (用DPTR1指针寻址,相当于有1K的片上xdata)。条件有限，没有上片试验，仿真而已。 打算将其移植到AVR上，但CodeAVRC与IAR EC++在结构体、指针的定义使用上似乎与C51不太一样，现在还未搞定。还希望在这方面有经验的网友能给予指导。-C51 with the Pinyin input method, which is rewritten netizens embuffalo. Unrivaled www.21ic.com available in the free publication of the original work by Kai-51 on the Pinyin input method procedures . Appreciate the use of a two-dimensional array for the look-up table, I think this is a waste of space. Each of the characters but the index table to manually input address, efficiency is not high. I use the structure to rewrite a bit. We see now is this. Because the code comparison, a total of 6, more than 000 Chinese characters, this must

用proteus仿真实现投币赌博机，编译软件：keil C -Simulation with proteus gambling slot machine, build the software: keil C

STC12C5410AD+128*64LCD（串行接口）AD转换+液晶显示程序-STC12C5410AD+128* 64LCD (serial interface) AD converter+ LCD program

新编万年历星期速算法C语言的实现-speed algorithm C implementation

很好的用io口模拟串口的程序，内带仿真文件，可随意修改，已经在产品中应用，可放心使用。-Io mouth with a very good simulation of serial procedures, within the simulation with documents, can be freely modified, has been applied in the product can be assured that use.

RF905 200米无线数据收发模块C语言程序-RF905 200 meter wireless data transceiver

读取RF射频卡源代码（C51）-RF card reader source code (C51)

用电子警察上面，在汽车有违章是 可以把他给抓拍下来-electronic above, the car can be a violation him down to snapper

基于gps的车载定位系统，使用STCc51来设计的车在定位系统-Gps based vehicle positioning system, the use of STCc51 to design the vehicle positioning system