PalmOs API，对做嵌入式的同仁有很好的参考价值，此文档对接口函数讲的很详细...

模糊PID控制器--Blur PID controller.

使用RSC232进行双机通信，只要有串行线就可以进行双机通信。（串行通信）-RSC232 dual use communication, as long as a serial line can hold two aircraft communications. (Serial communications)

中兴MG815+CDMA模块USB转接原理图及PCB图（基于CP2102的USB TO RS232转接原理-ZTE MG815+ CDMA module USB adapter and the PCB schematic diagram (based on the CP2102

6711开发板源程序-6711 development board source

这是一个uC/OS-II For S3C44B0x的移植项目源代码．可以在uCOSV252.exe上运行，绝对可用-This is a uC/OS-II S3C44B0x For the migration project source code. UCOSV252.exe can run absolutely available

qDecoder: Being a Web Application Interface for C/C++ use, qDecoder is a solution product for developers.-qDecoder : Being a Web Application Interface for C/C use. qDecoder solution is a product for developers.

这是通讯接口实验《8255A原理实验》的原理程序，适合于那些上嵌入式系统、通信、计算机专业的人-This is the communication interface experiment, "8255A principle experiment," the principle procedures, suitable for those on embedded systems, communications, computer specialists in the

输入工艺曲线后ＰＬＣ２００自动调节正负双极性输出的程序-After the input process curve of plus or minus PLC200 automatic adjustment procedure for bipolar output

FPGA verilog PS2 鼠标控制LED   PS2接收模块（电脑接收，鼠标发送） PS2_CLK信号由PS2设备产生,即鼠标在产生时钟的同时向主机送出数据，主机在PS2_CLK信号的下降沿读取(锁存)每个位。/*标准的鼠标有两个计数器保持位移的跟踪:X位移计数器和Y位移计数器。**可存放9位的2进制补码，并且每个计数器都有相关的溢出标志。**它们的内容连同三个鼠标按钮的状态一起以三字节移动数据包的形式发送给主机。**位移计数器表示从最后一次位移数据包被送往主机后有位移量发生。**位移计数器是一个9位2的补码整数。它的最高位作为符号位出现在位移数据包的第一个字节里。

金鹏电子出产的液晶ocm4x8b源代码，基于51单片机的，如果其他控制器请修改。-Jinpeng Electronics LCD ocm4x8b produced the source code, based on the MCU 51, if the other controller requested the modification.