a relatively good start Samsung Porting the code,

arm软件编程学习教程，对学习嵌入式软件编程的人很有帮助！-software programming arm study guides, learning embedded software programming helpful people!

并口Jtag 烧写flash工具的源代码-burning flash source tools

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

arm devlop keit program

magicARM2410试验箱的WinCE5.0使用说明-chamber magicARM2410 use of WinCE5.0

这是原版本开发的cdrom内容，但由于工厂生产，为什么没有下载，来之不易，是arm初学者必备的文档。

arm环境下开发以太网的程序，走过路过不要错过啊-Ethernet environment development arm of the procedure, passing through not miss ah

ARM 嵌入式系统开发典型模块_11_ADS1.2-ARM Embedded System Development _11_ADS1.2 typical module

此源码是sc3c2410的MEMORY读写测试程序，经实际测试，可以正常运行．-This source code is read and write sc3c2410 The MEMORY test procedure, the actual test can be normal operation.

arm的常用的指令集-arm commonly used instruction collection