鼠标的单片机驱动程序 把鼠标的四条线接在89c52 上把程序编译好后下载进去 就可使用。但要看好接口。...

经典的i2c程序-I2c classic procedure

凌阳单片机模拟6800时序，很多液晶的驱动可以用的上。-Sunplus simulated 6800 time series, a lot of LCD driver can be used on.

LCD应用显示keil编写非常实用的C程序-LCD display keil prepared very practical application of C-program

基于80C51系列的电机速度控制，能实现对电机转速的控制。-80C51-based series of motor speed control, can realize the control of motor speed.

程序由C语言编写，时序完全达到要求，含有proteus仿真图。硬件上已经测试通过！-Procedures by the C language, timing fully meet the requirement, contained Proteus simulation of Fig. Hardware has been tested!

基于电话网络的远程监测系统 附原理图及PCB图-Telephone network-based remote monitoring system attached schematic diagram and PCB

５１单片机开发的键盘扫描程序　希望对大家有用-Development of 51 single-chip microcomputer keyboard scanner hope useful for everyone

两相四线步进电机驱动,控制程序.C语言编写-Two-phase four-wire stepper motor driver and control program. C language

基于C51的DS1820测温的C语言源程序，有详细注释-c51 program about tempreture data acquisiton

AVR定时器功能 定时器每秒加一,0到255循环,通过数码管显示计数值-AVR timer function Timer per second, plus one, 0 to 255 cycles, through the LED display counts