FPGA的数码相框

红外解码程序，汇编语言，实际产品用过此代码-IR decoding, assembler language, the actual products used this code

主要讲了c8051f020实现PCA脉宽调制功能。-Major topics of the c8051f020 achieve PCA pulse-width modulation functions.

本程序功能是在FPGA上nios处理器的flash接口程序。-The program features in the FPGA on the Nios processor

U盘和MP3上用的Fat文件系统源码，已经在我的系统中实现-U disk and MP3 use the Fat file system source code had been in my system realize

主要讲了单片机对lcd2864液晶编程，十分好。-Major topics of the right lcd2864 LCD MCU programming, very well.

ARM裸机实验,基础学习,跑马灯实验-ARM bare-metal experiments, basic learning, marquees experiment

用430编写的SD卡读写程序，希望对大家有用。-Prepared with the SD card reader 430 procedures in the hope for all of us.

STM32F103C6与SD2405API实时时钟的I2C接口程序-STM32F103C6 with real-time clock I2C interface SD2405API program

本系统利用集成智能温度传感器测量温度，采用光纤传输温度信号。系统由单片机（HT46R24）控制温度传感器（DS18B20）的温度采集。当有采集温度的指令的时候，才启动温度传感器并采回其数据，在没有进行温度采集的时候，将通过抬高温度传感器的地，关断其工作电源，如此可以降低系统的功耗。系统将每一次采集回来的数据与前一次的数据比较，若温度变化超限或温升超标，立即发送上述温度值；否则，累加到采集了一定的次数，再向主机发送最新温度值。-The system uses an integrated smart temperature sensors measure temperature, using optical fiber transmission temperature signal. System consists of microcontroller (HT46R24) controlling the temperature sensor (DS18B20) the temperature of collection. When a collection of instructions, when the temperature before start-up temperature sensors and taken back to its data, collected in the absence of the temperature when the temperature sensor will raise, the turn-off the power of their work, so you can reduce system power consumption. The system will come back every time collecting data and previous data comparison, if the temperature changes or temperature exceeding overrun immediately send the temperature value otherwise accumulate to collect a certain number of times, again

上传一个arm调试软件，在xp下调试jtag经常出错，推荐使用该软件比较好用。-upload an arm debug software, under the xp JTAG Debugging often wrong, Suggested use the software more user friendly.