LIBUSB USB host

USB摄像头源代码 * usb-2.6.12.rar 是2.6内核的驱动 我现在用的就是这个 * usb-2.4.31.patch是2.4的， * servfox-R1_1_3.tar.gz 服务端的采集程序 * spcaview.rar 客户端查看程序，我还没捣鼓好 -USB camera source code* usb-2.6.12.rar is the 2.6 kernel driver I now use is the* usb-2.4.31.patch is 2.4,* servfox-R1_1_3.tar.gz server collection procedures* Show spcaview.rar client program, I have not yet捣鼓good

PIC单片机的USB嵌入式接口程序,用C语言编写-PIC MCU embedded USB interface program using C language

51单片机控制D12 USB器件的完整源代码, keil工程文件,可以在周立功开发板上运行-51 MCU control D12 USB device complete source code, c51 engineering documents, in the weeks running meritorious development board

usb的通用驱动源码-usb definitive source drive

实现U盘或移动硬盘插入和退出时得到事件响应，用户可以自己处理-Realization of U disk or mobile hard disk to be inserted into and exit in response to the incident, the user can handle

USB摄像头编程-USB camera Programming

非常好的的USB 接口程序 基于pic单片机-Very good procedures for the USB interface pic based on single chip

USB设备端固件程序,枚举部分是全部程序的基础和重心,只有主机对设备枚举成功后,主机才能和设备进行正常的通信 USB的枚举过程分为4个状态. 1.接入态 v主机检测到USB设备插上,击活端口,并发送复位命令(保持10ms) 2.默认态 v主机使用默认地址读取设备描述符 (GET_DESCRIPTOR) v主机分配给设备一个总在线的唯一地址 (SET_ADDRESS) 3.地址态 v主机从新的地址获取设备描述符(GET_DESCRIPTOR) v主机获取所有设备的配置描述符(GET_DESCRIPTOR) 4.配置态 v主机设置描述符(设备,配置) (SET_CONFIGURATION) v主机读取配置状态(可选) (GET_CONFIGURATION) v主机读取接口状态(可选) (GET_INTERFACE) -USB device-side firmware, enumerate all part of the foundation and focus of the procedure, only the host of equipment after the successful enumeration, the host and equipment in order to engage in normal communication USB enumeration process is divided into four status. 1. Access state v host detected USB devices plug in, hit live ports, and send the reset command (to maintain 10ms) 2. default state v Use the default address of the host to read device descriptor (GET_DESCRIPTOR) v host assigned to the equipment of a total online only Address (SET_ADDRESS) 3. A

2407上ucosii移植实现，值得参考-2407上ucosii移植实现，值得参考！！！！！！！！！！！！

softphone GUI