登录
首页 » 嵌入式系统 » 封装了主要C8051F系列单片机的原理图库

封装了主要C8051F系列单片机的原理图库

于 2022-01-24 发布 文件大小:14.47 kB
0 166
下载积分: 2 下载次数: 1

代码说明:

封装了主要C8051F系列单片机的原理图库-Packaging the main principle C8051F MCU Gallery

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • MM36SB020串行FLASH的简单例子
    MM36SB020串行FLASH的简单例子--A simple example for MM36SB020 serial FLASH.
    2022-04-24 11:48:17下载
    积分:1
  • 使用 VB.net 的串行通信
    此应用程序用于从计算机的串行数据发送到所述微控制器用于控制基于串行通信的任何应用程序。这种编码的设计使得它会给中的字符形式的输出结构。使用此代码,您可以以串行方式传送到 8 位单片机的串行通信的字符。........................................................................................................
    2022-01-28 21:45:01下载
    积分:1
  • cc2430zigbee通信方案。
    cc2430zigbee的通信程序 能够实现点对点的通信-cc2430zigbee communication programme.
    2022-07-08 11:04:24下载
    积分:1
  • 自制AvrJTAG仿真器资料,功能一点也不比ATMEL的差呀。
    自制AvrJTAG仿真器资料,功能一点也不比ATMEL的差呀。-homemade AvrJTAG simulator information, function is not worse than ATMEL ah.
    2022-12-19 01:55:03下载
    积分:1
  • 用于有线数字电视菲利普高频头的驱动程序,采用意法半导体的0297 qam解调芯片。解压密码:philips...
    用于有线数字电视菲利普高频头的驱动程序,采用意法半导体的0297 qam解调芯片。解压密码:philips-For cable digital TV tuner Philips drivers using STMicroelectronics 0297 qam demodulator chip. Unzip password: philips
    2022-01-28 13:23:26下载
    积分:1
  • 基于CH375的USB数据采集应用程序,上位机VB
    基于CH375的USB数据采集应用程序,上位机VB-CH375 of USB-based data acquisition applications, PC VB
    2022-02-18 13:35:05下载
    积分:1
  • NIOS II 与USB接口的程序,用于周立功FPGA的开发板,自己的开发板只需修改引脚即可...
    NIOS II 与USB接口的程序,用于周立功FPGA的开发板,自己的开发板只需修改引脚即可-NIOS II with the USB interface procedures for weeks Ligong FPGA development board, its own development board can only modify pin
    2022-08-07 10:42:34下载
    积分:1
  • STM8S 通用输输出接口
    本应用笔记提供简短说明示范固件发现的,预先在 STM8S003K3T6 单片机的闪存中。这个示范固件使使用的基本的 8 位定时器配置为 STM8S时基发生器来改变 LED LD1 的闪烁速度
    2022-11-08 21:55:03下载
    积分:1
  • 无刷电机驱动原理图及数据电子书
    Brushless Motor Drive Schematic & Data ebook
    2022-07-19 11:06:00下载
    积分:1
  • Xilinx IIC IP
    由 Xilinx 提供的 IIC 接口,使用 AXI interface。 Features ‧ AXI interface is based on the AXI4-Lite interface ‧ Master or slave operation ‧ Multi-master operation ‧ Software selectable acknowledge bit ‧ Arbitration lost interrupt with automatic mode switching from master to slave ‧ Calling address identification interrupt with automatic mode switching from master to slave ‧ START and STOP signal generation and detection ‧ Repeated START signal generation ‧ Acknowledge bit generation and detection ‧ Bus busy detec ‧ Fast mode 400 KHz operation or standard mode 100 KHz ‧ 7-bit or 10-bit addressing ‧ General call enable or disable ‧ Transmit and receive FIFOs - 16 bytes deep ‧ Throttling ‧ General purpose output, 1 bit to 8 bits wide ‧ Dynamic Start and Stop generation ‧ Filtering on the SCL and SDA signals to eliminate spurious pulses
    2023-09-07 01:15:03下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载