A very classic one microcontroller electronic clock word document, I believe you...

Luminary cotex-M3 CAN总线 源代码-Luminary cotex-M3 CAN bus source code

这是我画的步进电机通用的驱动板，当然只是应用到初学者，版胡德不是很好，希望大家多多指教。-This is my painting of the stepper motor drive GM board, of course, only applied to the beginner, not a very good version of Ehud, I hope everyone exhibitions.

用C51I/O口来驱动两个四位数码管，并且可消隐，降低功耗。-With the C51I/O port to drive the two four digits

串口模拟程序，与电脑联机使用，使用51单片机。-Serial simulation procedures, and computer on-line access, the use of single-chip microcomputer 51.

有电路图和程序,都是正确的.如果有问题可以到我的博客 去留言,大家相互学习-A circuit diagram and procedures are correct. If the problem can go to my blog to the message, we learn from each other

MSP430F149读写EEPROM2402-MSP430F149 read and write EEPROM2402

C8051F040单片机CAN总线互相通信程序 -C8051F040 single-chip CAN bus communication procedures with each other

凌阳单片机（SPCE061A）IIC总线驱动程序-Sunplus Singlechip (SPCE061A) IIC bus driver

带农历显示的万年历,功能齐全，附电路图，可以做产品。-With the Lunar calendar display, complete functions, with schematics, can make products.

用loop51实现的可调式脉冲发生及检测器，可以手动输入所发生脉冲的频率和占空比，实时检测及动态显示-loop51 achieved with adjustable pulse and the detector, which can occur manually input pulse frequency and duty cycle, real-time detection and dynamic display