上海和上海健康电子的单片机易入门…

基于C51单片机驱动舵机的程序 C语言编程可控制多个舵机-C51-based single-chip driver steering procedure C language programming can control a number of steering gear

HT24 系列的EEPROM 总共8 个管脚，三个为芯片地址脚A0、A1、A2，在单片机对它进行操作时，从SDA 输入A0、A1、A2 数据和芯片外部A0、A1、A2 所接地址需一一对应。一个为芯片写保护脚WP，WP 脚接低电平时，芯片可进行读写操作；WP 脚接高时，芯片只可进行读，不可进行写。 另外两个管脚为电源脚VCC，VSS。 用单片机对HT24 系列的EEPROM 进行控制时，HT24 系列的EEPROM 的外部管脚VCC、VSS、WP、A0、A1、A2 根据需要，对应接上，SDA、SCL 接到单片机控制脚上。-HT24 Series EEPROM total of 8 pins, three pins for the chip address A0, A1, A2, in the microcontroller to operate it, from SDA input A0, A1, A2, and chip external data A0, A1, A2 of the Then one correspondence address must be in. One for the chip, write-protect pin WP, WP feet then low, the chip can be read and write operations WP pin is high then, the chip can only be read, not write. The other two pins for the power pin VCC, VSS. With the microcontroller on the HT24 Series EEPROM control when, HT24 Series EEPROM external pin VCC, VSS, WP, A0, A1, A2 according to the needs of the corresponding connected, SDA, SCL receives SCM control feet .

通过编程实现对LCD的驱动，实现能在LCD显示器上显示字符和数字。-Through the programming of the LCD driver, able to realize in the LCD display to show characters and numbers.

AVR ATMega8 Modbus protocol implementation

Proteus仿真实验经典12例程 Proteus仿真实验经典12例程-Proteus simulation routines Proteus classic 12 classic 12 simulation routines

单片机16*16滚动点阵的功能是，LED屏显示的初步程序设计入门-Single Chip 16* 16 dot matrix of the function of rolling, LED screen display of the initial program design entry

单片机51控制硬盘的程序，含读写信息，可参考一下-control procedures on the hard drive containing information literacy, it can make reference to

PIC18（现在PIC18的下载资源太少了）的马达速度测试程序。-PIC18 (download now PIC18 too few resources) and motor speed test program.

用C51实现模糊控制器的软件设计,51系列单片机接口.定时器中断等。-C51 realize the fuzzy controller with the software design, 51 Series MCU Interface. Timer interruption.

通过这个程序，你可以知道电话是怎样拨号，是怎样接通，怎样传输。-through this procedure, you know how to dial telephone is connected to what, how transmission.