And the basic use of a BCB control RS

串口程序，使用vc编写，好东西，大家可以分享一下。-Serial procedures, the use of vc preparation, good things, we can share.

通过串口发送at指令 等待返回值判断当前的网络状况以及服务商等有关信息 用与gprs的通信-sent through the serial port at the value orders waiting to return to judge the current state of network service providers and other relevant information in communications with EDGE

串口通讯编程包括网络流量监控的等程序VC++编程语言与大家共享-serial communications programming, including network traffic monitoring procedures VC programming language and share

此串口调试程序加入了三菱PLC通讯调试，有源码及运行程序

本源码主要是通过API函数实现串口打开，读写串口和关闭串口。-the source mainly through API functions Serial opened, read and write serial and serial closed.

串口通信自动检测程序，已经通过测试，能够成功在2812板上运行。-Automatic detection of serial communication program, has passed the test, be able to successfully run on the board at 2812.

介绍了Linux下的串口驱动的设计层次及接口, 并指出串口与TTY终端之间的关联层次(串口可作TTY终端使用)-Describes the serial port under Linux-driven design and interface level, and noted that the serial link between the terminal and the TTY level (TTY serial port can be used for end-use)

一个很实用的串口调试软件，需要设置的变量很少。-a very practical serial debugging software, the need for a few variables.

msp430串口程序 MSP430_UART_DEMO-procedures MSP430_UART_DEMO Serial Controller

dephi实现RS232串口通信。本程序需要一根RS232串口线连接两个串口实现。本程序包括两个部分：发送端和接收端，分别打开两个文件夹里名为SerialPortCom.exe的程序，在发送端输入数据，然后就可以在接收端看到发送端输入的数据。-dephi achieve RS232 serial communication. This process requires an RS232 serial link two Serial Port. This program consists of two parts : the sender and the receiver, respectively, opened two folder called SerialPortCom.exe procedures, the transmitter input data and then on the receiving end can see the transmitter input.