lpc2300 技术笔记开发例程 uart

最初学习单片机的时候，由于条件，没有硬件，就只好用Proteus仿真，其实效果蛮不错的。到后来的高版本，直接可以支持ARM。相当不错的工具。此源码是其对uCOS在ARM上运行的仿真。-MCU when the initial study, due to conditions, not hardware, they can use Proteus simulation, in fact, quite a good effect. Later versions of the high direct support ARM. Pretty good tool. This source is its uCOS running in ARM emulation.

这次发个ucos270的ucosii，其他代码我会陆续发送，请等待-Ucos270 the fat of the ucosii, other code I would have sent, please wait

值得参考的ucos的tcpip协议源程序,带说明文档-worthy reference CENTER source of TCPIP agreement, with documentation

FSL GP32 ucos 1234567890 -FSL GP32 ucos

ucos操作系统源码，包括所有的源文件和头文件(ucos operating system source code, including all source and header files)

uCOS-II内核移植到STC单片机的全部源代码和应用软件，基于STC5A60S2(uCOS-II kernel ported to STC microcontroller full source code and application software)

周立功LPC2378 UCOS 模板，只需直接使用(LPC2300 ucos template，use it freely)

UCGUI3.32版本的使用手册，注意了，不是网上常见的32404版本，要的快下：）-UCGUI3.32 version of the user manual, attention is not on-line version of 32,404 common to the quick :)

本光盘提供了 嵌入式系统一些通用模块源代码，比如 键盘扫描器，显示器接口，计量器和输入输出，大部分代码是用可移植的C语所写。-the CD provided some common embedded system module source code, for example, the keyboard scanner, display interface, metering and input and output, with most of the code is portable C language written.

uCOS在PIC芯片中的移植：以PIC24HJ64GP210为例进行uCOS在Microchip芯片中的移植-uCOS in the PIC chip transplantation: PIC24HJ64GP210 as an example to uCOS chip in Microchip transplant