一个基于时钟芯片1302的单片机时钟。使用伟福的仿真器编译通过，同时写入单片机后的硬件电路也好使。...

详细介绍 智能仪器的基本数据处理算法 适合系统学习的人员 仅供参考-The basic details of intelligent instruments systematic study of data-processing algorithm is suitable for staff reference

C8051F020串口通信例程-C8051F020 serial communication routines

c8051f020 i2c 源码。对其操作有详细描述。-dvsah dfvdnjkg b fdv

采用两片凌阳61实现的建简易智能车程序，包含寻迹，金属探测，语音播报等功能-The use of two 61 Sunplus built realize the mini-mental procedures, including tracing, metal detector, voice broadcast and other functions

MCS-51单片机结构。由ATMEL公司生产的89C51将EPROM改成了4K的闪速存储器，他们的结构大同小异，本章将对8051单片机的结构作一介绍。-MCS-51 single-chip structure. ATMEL Corporation by 89C51 production will be replaced with 4K of EPROM flash memory, they more or less the same structure, this chapter will be the structure of 8051 for an introduction.

其中的usb端口通信已经作为一个模块来使用，用户只需用以下函数就可以对usb端口进行方便地读写： unsigned char D12_WriteEndpoint(unsigned char endp, unsigned char len, unsigned char * buf) 此为usb端点输出函数，endp是要进行通信的端点，取值为3（普通端点，最大可一次传输16byte）或5（主端点，最大可一次传输64byte）；len为一次输出数据长度；*buf为数据所在位置。 usb端点数据的读操作是由底层函数自动完成的（相关函数为unsigned char D12_ReadEndpoint(unsigned char endp, unsigned char len, unsigned char * buf)； 相应端点为2和4），所读到的数据存于GenEpBuf[]（普通端点）、MainEpBuf[]或EpBuf[]（主端点）中，用户可以直接读取使用。-Usb port communication which has been used as a module, the user can use the following function on the usb port can easily read and write: unsigned char D12_WriteEndpoint (unsigned char endp, unsigned char len, unsigned char* buf) This is the endpoint usb output function, endp is to communicate the endpoint, the value for 3 (common endpoint, the first transmission maximum 16byte) or 5 ( the main endpoint, the first transmission maximum 64byte) len Length of output data for the first time * buf location for data. usb endpoint data is read

单相电子式复费率电表解决方案,是很好的电表方案！也是很那找到的方案-Single-phase electronic multi-rate meter solutions, is a very good meter program! It is found that the program

lcd module for freaks

此源代码为UC/OS-II移植到51单片机的源代码.包括OS_CPU.H,OS_CPU_C.C,OS_CPU_A.S三个主要文件-this source code for the UC/OS-II transplants to 51 SCM source code. Including OS_CPU.H, OS_CPU_C.C, OS_CPU_A.S three key documents

这是CAN总线收发器SJA1000的控制程序,采用C语言编写的,有一定参考价值,-CAN transceiver SJA1000 control procedures, using the C language, a certain reference value,