S3C6400 srom controller,srom controller

数字I/O实验主要完成的功能： 在此实验中，SEED-DEC5416 首选进行初始化，包括对外设 UART、本身频率的设定及一些状态区的初始化。然后等待 SEED-MMI5402 发送命令；SEED－DEC5416 响应交通灯自动模式、交通灯手动手动模式、交通灯东西通、交通灯南北通、及交通灯的禁行与夜间模式的操作命令。同时还响应，对 SEED-DEC5416 的复位及两个单元之间的通讯故障。 -Digital I/O completion of the experiment the main features: In this experiment, SEED-DEC5416 preferred to initialize, including peripherals UART, their frequency settings and some of the initialization state of the district. SEED-MMI5402 and then wait to send commands SEED-DEC5416 automatic mode in response to traffic lights, traffic lights manual manual mode, the traffic light east-west pass, pass traffic lights north and south, and traffic lights at night and cut-line mode command. At the same time, also responded to the SEED-DEC5416 reset and communication between two modules fault.

在DSP6416T上实现的二次引导程序，可以对烧写的程序进行二次引导！-DSP6416T achieved in the second guided procedure, the procedure can be carried out on the programmer to guide the second!

TI DSP28035的电机驱动软件，供大家参考。

电力系统远动子程序,已经完全调试通过,方便使用TI公司2407DSP的同行应用,请放心使用-Power system telecontrol subroutines, debugging has been fully approved, to facilitate the use of TI company 2407DSP peer application, please rest assured that the use of

dsp2812程序算法，在RAM中调试，已经调试通过-dsp2812

DSB-SC信号的生成与解调 1) 用离散（DSP）的方法生成DSB信号 2) 载波频率为150KHz，音频为500Hz和2000Hz的混合音。 3) 加入高斯白噪声 （4） 语音信号 的传输。 改变抽样频率和量化台阶大小，观察重建信号以及量化噪声信号的波形；对于语音信号主观评价声音质量的变化。 -DSB-SC signal generation and demodulation 1) Discrete (DSP) methods to generate DSB signal 2) the carrier frequency to 150KHz, audio 500Hz and 2000Hz for the mixed tone. 3) by adding white Gaussian noise (4) transmission of voice signals. Change the sampling frequency and quantization step size, to observe the reconstruction of signal and quantization noise signal waveform for subjective evaluation of the speech signal changes in sound quality.

DCT算法在DSP上的实现，汇编语言，在DSP开发板上调试通过-DCT algorithm on DSP realization of assembly language, in DSP development board through debugging

DSP的CAN总线通信实验程序，包括CAN模块初始化和设置程序-DSP s CAN bus communication experimental procedures, including the CAN module initialization and setup program

TI f2812 dsp LAN commucation source code

正弦波发生器，c语言编制的DSP实验测试程序。-sine wave generator, c language DSP experimental testing procedures.