呵呵 一些及其简单的源代码 不是我的垃圾 而是我实在太急需要一些东西了 抱歉了 大家...

这是一个流水灯加汽灯控制程序。采用四位的拨码开关，低电平有效。-This is a wasted signals Yiding control procedures. The use of dial-4 switches, low-level effective.

AT91SAM7S32的一个应用.本程序为为一个简单的DEBUG口的输出演示： 1，完成基本的初始化 2，初始化DEBUG口，使能发送和接收 3，现象为在超级几终端打印信息-AT91SAM7S32 an application. The procedure for a simple mouth DEBUG output exercise : a complete two basic initialization, initialize DEBUG mouth so that it can send and receive three. the phenomenon of a few super information terminals Print

一个控制城市夜景霓虹灯的程序，带proteus仿真。喜欢的可以看看哦-City night lights a control procedure, with proteus simulation. Oh look at like

汇编源码 写注册用源码 可自定义皮肤 ASM源码-Compilation of source code was registered with the source code can be customized skin

一个用汇编程序写的美女程序-with a compilation of her writing process procedures

改进的七段显示电子钟-showed improvement in paragraph 107 of the electronic bell

dos下的网卡驱动程序。支持一般通用网卡，intel的8139系列。-card under dos driver. Support the general use card, intel

单片机AT89C2051来编程，轻触式步进调整控制电路。原理图、源程序。-Single-chip AT89C2051 to programming, touch-step adjustment control circuit. Schematics, source code.

MCS-96单片机要用PWM产生锯齿波，应使PWM寄存器中的值线性增加，那么在PWM输出端将得到宽度线性增加的脉冲波，经滤波后，便可得到锯齿波。-MCS-96 microcontroller with PWM have Sawtooth, PWM register should be the value of linear increase, then the PWM output will be increased linearly width of the pulse wave, After filtering, it will be Sawtooth.

拖动鼠标画线，圆，矩形的例子-Drag painting line, circle, rectangle example