This program writes a lcd HyperTerminal and everything you type on your keyboard...

串口通信软件,在上位机上很好用,方便上位机监控-uart vC++ uart vC++uart vC++uart vC++ uart vC++uart vC++

Corrado Cavalli为VB.NET写的串口通讯类。通过调用API的方法与串口通讯。我的有关串口通讯的程序都是用的这个类。-Corrado Cavalli to write VB.NET serial communications. By calling the API methods and serial communications. Serial I of the communications procedures are used in this category.

串口制医疗器械的程序-medical equipment procedures

楼宇自控系统 顾名思意。 （注意：需要专用硬件支持。）-Building Automation System Advisory Board were thinking Italy. (Note : the need for dedicated hardware support.)

本程序是通过串口，经由单片机控制电机转速的程序。该程序通过串口发送不同的信号，以实现控制通信。-this procedure is adopted Serial through SCM motor speed control procedures. The procedure adopted Serial send different signals to achieve control and communication.

实现数据链路层 串口间的通讯，可以调试网络间的简单连接-Data link layer communication between serial port, you can debug a simple connection between networks

串口编程-云台镜头控制系统,可以自由设置发送代码和串口选择。-Serial Programming- PTZ camera control system, can freely set the send code and serial port options.

多谢，大本营的对我的帮助。这是一个串口调试程序，供大家参考。-Thank you, the stronghold of my help. This is a serial debugger, for your reference.

MSComm32.ocx串口通信程序。测试时不要用虚拟串口，直接将串口2引脚与3引脚短接。-MSComm32.ocx serial communication program. Not to test with virtual serial port, serial port directly to 2-pin and 3 pin shorted.

GSerial是一个DOS下串口通信程序，程序结构较好，能编出用中断方式接收/发送的多串口通信程序（龚建伟曾用它编过7串口通信程序）。Turbo C++ 3.0 Dos或 Win3X/9X/ME/NT/2K的DOS环境下运行-GSerial under DOS is a serial communication program, program structure better, can be compiled out with interrupt receiving/sending of multiple serial communication program (Dan has used its seven series serial communication procedures). Turbo C 3.0 Dos Win3X/9X/ME/NT/2K or the DOS operating environment