登录
首页 » Others » cavity_resonators

cavity_resonators

于 2021-03-23 发布
0 514
下载积分: 1 下载次数: 7

代码说明:

说明:  利用comsol实现了空腔谐振腔(矩形,圆柱,球形)的仿真,并实现了谐振频率和品质因数的测量。(The simulation of cavity resonator (rectangular, cylindrical, spherical) is realized by COMSOL, and the resonant frequency and quality factor are measured.)

文件列表:

cavity_resonators .mph, 64296378 , 2020-10-31

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • olen
    olen方法,通过增加干扰源进行旁瓣的抑制,使用在与数据相关的阵列信号处理(the olen method,which used for array process assiciated with data, suppress side-lobe level by inserting interface source)
    2010-01-04 16:13:37下载
    积分:1
  • vb
    说明:  利用vb操作xml文件,进行读写操作.适合学习vb的人下载(Use VB to operate XML files for reading and writing. People who are suitable for learning VB Download)
    2018-01-18 10:04:45下载
    积分:1
  • 42-2987-1-PB (1)
    he rotor/load angle is the angle between induced emf & terminal voltage in a 3-phase alternator & also the angle between rotating vectors of stator & rotor fluxes. Torque produced directly depends upon this angle.
    2020-06-24 11:00:02下载
    积分:1
  • 12864
    利用STM32F429显示DHT11采集到的温湿度(Display temperature and humidity collected by DHT11 by STM32F429)
    2020-10-03 15:27:41下载
    积分:1
  • digital processing of SAR data
    说明:  合成孔径雷达成像算法与实现(附光盘数据和仿真代码)(SAR imaging algorithm and implementation (with CD data and simulation code))
    2019-03-11 17:16:59下载
    积分:1
  • This is dump from Welltech TV
    This is dump from Welltech TV
    2022-08-13 14:50:38下载
    积分:1
  • 通过分析程序开发
    Embedded vc++下开发的路经分析程序-developed under the passing analysis program
    2022-08-04 08:13:04下载
    积分:1
  • 3040
    基于K均值的PSO聚类算法,光纤无线通信系统中传输性能的研究,ML法能够很好的估计信号的信噪比。( K-means clustering algorithm based on the PSO, Fiber Transmission wireless communication system performance, ML estimation method can be a good signal to noise ratio.)
    2017-05-08 15:33:39下载
    积分:1
  • boost
    升压斩波电路(Boost)的仿真 针对 Boost 变换电路,完成以下工作: (1) 在 MATLAB/SIMULINK 下搭建 Buck 电路仿真模型,并设置好各个模块的参数; (2) 分别选择 3 个不同的占空比,用示波器同时观察 E,uGE,i1,io,uo 以及电感两 端的电压 uL和流过电容的电流 iL的波形(注意频率的选择)。(Boost simulation model is built under MATLAB / SIMULINK, and the parameters of each module are set up. (2) Choose three different duty cycles and simultaneously observe E, uGE, i1, io, uo and inductance with an oscilloscope. Voltage UL at End and Current iL Waveform through Capacitor (Attention to Frequency Selection)
    2018-12-12 21:49:00下载
    积分:1
  • 域名防红
    Please wait for a few minutes to an hour after the completion of the anti-red upload, and the download can not be opened until the auditor has completed the audit. If the upload is not opened for more than an hour, please leave a message in the message board. (How about waiting for more upload failures when large files reach 99%)
    2020-06-25 14:00:01下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载