深度置信网络

说明：  利用动态规划算法求解最优路径，混合动力卡车、扭矩分配，SOC估计(Using dynamic programming algorithm to solve the optimal path)

使用WSN的nets实现的编程代码，用于ＷＳＮ的一般建模(The use of WSN programming code to achieve the nets for the general modeling WSN)

在分析自适应模糊控制及PID参数变化对系统性能影响的基础上,提出在动态过程中对PID参数进行整定.仿真研究表明,控制质量得到了提高.(In the analysis of adaptive fuzzy control and PID parameter changes on the basis of system performance, tuning the PID parameters in the dynamic process simulation studies have shown that quality control has been enhanced.)

genetic_algorithm optimized matlab program_abaqus

自己做的： （一）用双线性变换法设计并用实验系统实现一个三阶的契比雪夫Ⅰ型低通数字滤波器，其采样频率Fs =8KHz，1DB通带边界频率为fp=2KHz。 （二）用双线性变换法设计并用实验系统实现一个三阶的契比雪夫Ⅱ型高通数字滤波器，其采样频率Fs =16KHz，阻带边界频率为fst =4KHz(matlab gui)

matlab版本的特征生成的SIFT算法(SIFT algorithm, matlab version)

中心化后的傅里叶谱，傅里叶频谱和平均值,计算图像的平均值(Fourier spectrum and average value)

This program simulates wave propagation in a medium that has impedence matched between two slabs and hased been used Mur ABC for no reflection at two ends.

基于全相位傅立叶变换apFFT的滤波程序(Based on all phase Fourier transform apFFT filtering program)

牛顿插值法和三次样条插值法的程序，也对这两种方法的效果进行了对比。(Program of Newton interpolation and cubic spline interpolation method, and also compared the effect of these two methods.)