vector_control

在计算切削力的过程中，需要计算切削力系数，主要用于切削力系数的计算(calculation of cutting force coefficient)

基于matlab/simulink的反激变换器仿真(Based on matlab/simulink simulation flyback converter)

主要是forbild胸部体模的matlab程序(forbild throax phantom)

In sum capacity of an OFDM system is maximized by allocating each subchannel to the user with the highest channel gain over this channel and distributing power among subchannels in a water-filling manner.

说明：  全相位APFFT与传统的FFT算法对频率和相位进行估计(Frequency and phase estimation of all-phase APFFT and traditional FFT algorithm)

泰勒算法定位，语言采用的是matlab编程，用于实现无线定位中的泰勒算法(Taylor positioning algorithm, matlab programming language is used for wireless location algorithm Taylor)

在发射端产生OFDM信号，生成信号的波形已被画出。(OFDM signal generated at the transmitter side, the signal generated waveform is drawn.)

Triangle Wave Generator

产生线性调频信号的方法很多，压缩包中包含两种产生线性调频信号的方法程序(Are many ways to generate a chirp signal compression package contains two chirp signal)

数值分析要求：第二题编成命令文件即可，其中阶乘可以单独编成函数文件在命令文件中调用，也可以直接在你所编的命令文件中利用循环语句直接计算； 第四题编成通用的程序，建议编成函数文件。提示：可以把多项式的系数和所需要求解的点设为参数。(Numerical Analysis of requirements: the second title of the command file can be compiled, which can factorial function into a separate file in order to call the document can also be made directly in your document, use the command loop direct calculation into fourth title common procedures, the proposed document into function. Tip: polynomial coefficients can be requested and the required parameters set point solution.)