-
pip_audio
这是一段用于谱分析算法中的求蝶形算子的
子程序,此程序采用C语言编写,移植性比较强(This is a period for the spectral analysis algorithm for the subroutine butterfly operator, this procedure using C language, the transplantation of relatively strong)
- 2008-03-17 18:31:09下载
- 积分:1
-
turbofangzhen
这是关于turbo码的编译码的仿真程序,并附有仿真图(This is a turbo code codec on the simulation program, together with the simulation of Figure)
- 2008-03-20 21:44:45下载
- 积分:1
-
Ponomarev
Ponomarev Fixed Structured Automata Matlab Code
- 2011-08-23 03:04:00下载
- 积分:1
-
4DOF-manipulator-simulation-
本文章描述四自由度机械臂的matlab仿真方法,使用到robot工具箱(This article describes the four degrees of freedom manipulator matlab simulation method using the robot kit)
- 2015-04-02 20:47:12下载
- 积分:1
-
grey_model
用matlab实现了五类灰色关联度模型的计算,包括邓氏关联度、绝对关联度、斜率关联度、改进绝对关联度、T关联度。附带两个测试用数据列的生成函数。(Matlab achieved with five gray correlation model calculation, including the Tang correlation degree, the absolute correlation, the slope of correlation to improve the absolute correlation, T correlation. Attached to the two test data out of the generating function.)
- 2008-05-08 19:56:28下载
- 积分:1
-
MODELING_BAND_PASS_SIGMA_DELTA_MODULATORS_IN_SIMUL
如何在Simulink中搭建Sigma Delta ADC的非理想模型
MODELING BAND-PASS SIGMA-DELTA MODULATORS IN SIMULINK(MODELING BAND-PASS SIGMA-DELTA MODULATORS IN SIMULINK)
- 2009-06-14 08:32:05下载
- 积分:1
-
ARL_7_read
Sobel edge detection algoritmh to detec edge.
- 2012-03-22 16:54:49下载
- 积分:1
-
Prony
添加了滤波环节、去直流环节并且用了SVD-TLS算法改进后的Prony算法(Add a filter link, go to the DC link and use the SVD-TLS algorithm improved Prony algorithm)
- 2021-03-30 21:49:09下载
- 积分:1
-
CODE
本文概述了使用MATLAB图像去噪的基本原理。以小波分析法为重点,对常用的几种去噪方法进行了分析比较。最后结合理论分析和实验结果,讨论了一个完整去噪算法中影响去噪性能的各种因素。(This paper outlines the basic principles of image denoising using MATLAB. Wavelet analysis, focusing on several commonly used de-noising methods were analyzed and compared. Finally, the theoretical analysis and experimental results, discusses the various factors that affect a complete de-noising algorithm denoising performance.)
- 2015-01-09 09:33:42下载
- 积分:1
-
传递对准程序 naoqu a maste
很好的传递对准程序 ,讲述的是有关于 挠曲变形建模型的(Transfer alignment procedure is very good, is told about the flexural deformation model)
- 2014-07-04 22:13:00下载
- 积分:1