bp

1. 针对推挽结构MZ-LiNbO3调制器； （1）通过MATLAB编程画出输出电场、输出功率传递函数随外加波导两臂相位差的变化曲线； （2）确定相位调制器、强度调制器的偏置电压； （3）假设理想条件下强度调制器消光比为20dB，通过MATLAB编程画出消光比曲线随3dB耦合器分光比的变化。（分光比R=0.45:0.05:0.55）(1. For push-pull MZ-LiNbO3 modulator; (1) The curves of the output electric field and the output power transfer function with the phase difference between the two arms of the external waveguide are drawn by MATLAB programming. (2) Determine the bias voltage of phase modulator and intensity modulator; (3) Assuming that the extinction ratio of intensity modulator is 20 dB under ideal conditions, the extinction ratio curve of intensity modulator varies with the splitting ratio of 3dB coupler by MATLAB programming. (Spectrum ratio R = 0.45:0.05:0.55))

基于RBF神经网络自适应控制的一级直线倒立摆仿真——simulink(linear inverted pendulum simulation based on the RBF neural network adaptive control)

用于sms数据处理，为fvcom准备输入文件(prepare for FVCON input file)

esquemas y codigos vagcom 18.9.0

程序使用的是STC12C5A系列单片机，程序功能是,STC12C5A60S2-串口1-串口2-测试程序(The program uses STC12C5A series MCU, the program function is, STC12C5A60S2- serial 1-port 2-test program)

说明：  用于比较计算两幅图像的均方误差值MSE大小(It is used to compare and calculate the MSE of two images)

自己编写的GMSK信号的循环谱密度程序，开发平台MATLAB，对于循环谱检测有一定的参考价值！-I have written the cycle of GMSK signal spectral density procedures, development platform MATLAB, for the cyclic spectrum detection of some reference value!

nRF24L01驱动，基于LM3S1138(nRF24L01 driven, based on LM3S1138)

非线性降维, 使用者必须自己准备数据，可以对立面的参数进行修改(nonlinear dimesion reduction,This package is free for academic usage. You can run it at your own risk.)

用贪婪算法寻找交换机的最佳匹配端口，效率比较高，时延抖动也比较小-Greedy algorithm used to find the best matching switch port, the efficiency is relatively high, delay jitter is also relatively small