film-UMATHT

超结构光栅、啁啾光栅、长周期光栅切趾仿真(The simulation of the chirped grating and the long period grating)

利用分形维数原理计算分段测井曲线的盒维数，从而定量化曲线分形特征。利用雷达图对分形数据进行分析。(The fractal dimension principle is used to calculate the box dimension of segmented logging curves, and the fractal characteristics of curves are quantified.)

surfer软件模型转化到3dec直接应用的小程序(Small program of transforming surfer software model into 3DEC direct application)

学习编写EA的基本内容，了解编写EA的基础方法。(Learn to write the basic content of EA and understand the basic method of compiling EA.)

说明：  风力发电机mppt控制程序，基于扰动观察法(The program of PWSM mppt)

说明：  三极管放大实验电路，包括固定偏置/分压偏置，需要根据一些参数确定所选用的电阻值，使得三极管工作在放大状态。本程序将电路设计设计成GUI模式，界面上只需要输入电路设计所需参数，根据相关理论推导，给出相关参数的理论值（放大倍数、输入电阻、输出电阻等），指导实验电路搭建。软件搭建在matlab gui上，方便使用 若干参数说明 beta：三极管放大倍数 Ic：集电极电流 Uce：期望CE间电压 UeCof：Re电阻上点电压与Ucc电压比值，一般0.1-0.2 IbCof：Ib上电流与流过Rb1、Rb2电流的比值，一般0.1 ShuntCe：是否有旁路电容(The experiment circuit of triode amplification, including fixed bias / partial voltage bias, needs to determine the selected resistance value according to some parameters to make the triode work in the amplification state. In this program, the circuit design is designed into GUI mode. Only the parameters needed for circuit design are needed on the interface. According to the relevant theoretical derivation, the theoretical values of the relevant parameters (magnification, input resistance, output resistance, etc.) are given to guide the construction of experimental circuit. The software is built on Matlab GUI, easy to use)

说明：  ABS计算模型，动态仿真！模型模型模型模型模型模型模型模型(ABS calculation model, dynamic simulation! Model model model model model model model model)

说明：  根据卫星坐标和接收站坐标来计算卫星高度角的一段程序，简单实用(A program for calculating satellite altitude angle based on satellite coordinates and receiving station coordinates is simple and practical.)

利用状态方程在时域求解颤振速度 希尔道森气动力(aeroelastic flutter theodoson)

说明：  采用相场方法，计算纯物质枝晶生长，标记为相场模型C。(Dendrite growth of pure substance was calculated by phase field method, marked as phase field model C.)