64-bit-array-multiplier

simulink实现载波PAM信号传输并计算不同信噪比下的误码率(PAM Modulation In Simulink)

针对通信侦查课题，通过已知先验知识和截获信号，进行找出同步序列，匹配滤波，校正频偏和相偏，均衡，解交织，译码，恢复出原序列，最终得到的序列与原序列作对比得到误码率为0(Investigation subject for the communication, by known a priori knowledge and intercepted signal conducted to identify the synchronization sequence, the matched filter, correcting frequency offset, and phase deviations, balanced, deinterleaving, decoding, to recover the original sequence, the resulting sequence with the original sequence compared error rate is 0)

5 System design and signal processing for OFDM-based wireless communication systems.pdf

对学习AD HOC网络很有帮助的一些电子文档，可以了解此网络的基本原理和一些协议之间的比较，以及改进。大家看看肯定会有所帮助哦(The study of electronic document helpful AD HOC network)

1 联合开发网 - pudn.com

本书描述了4G LTE / 5G NR 无线接入技术。(This book describes LTE, developed in 3GPP and providing true fourth-generation (4G) broadband mobile access, as well as the new radio-access technology 3GPP is currently working on. Together, these two technologies will provide 5G wireless access.)

说明：  在实际的调谐解调电路中，采用的是非相干载波解调，本振信号与发射端的载波信号存在频率偏差和相位抖动，因而解调出来的模拟I、Q基带信号是带有载波误差的信号。这样的模拟基带信号即使采用定时准确的时钟进行取样判决，得到的数字信号也不是原来发射端的调制信号，误差的积累将导致抽样判决后的误码率增大，因此数字QPSK解调电路要对载波误差进行补偿，减少非相干载波解调带来的影响。(In the actual tuning and demodulating circuit, non-coherent carrier demodulation is adopted, and the frequency deviation and phase jitter of the local oscillator signal and the carrier signal of the transmitting end are present, and thus the demodulated analog I and Q baseband signals are signals with carrier error.)

杨建国老师的通讯原理课件，第三章模拟信号的调制与解调，主要讲述信号产生与调制，射频特性，解调，MSK、GMSK、PSK、QPSK、BPSK、QAM等原理(Yang Jianguo teacher communication principles of courseware, the third chapter of the analog signal modulation and demodulation, and focuses on the signal generation and modulation, the RF characteristics, demodulation, MSK, GMSK, PSK, QPSK, as BPSK, QAM and other principles of)

用与电话和电脑的串行通讯，用的是VB写的一些介绍和实例(Used with the telephone and computer serial communications, using VB to write the introduction and examples of some)

说明：  按信源编码、信道编码、传输、解码、计算分析的过程模拟实际MIMO技术的误比特率(Simulate the bit error rate of real MIMO technology according to the process of source coding, channel coding, transmission, decoding and calculation analysis)