test

用于驱动2.13英寸的墨水屏，电纸屏。包含arduino、STM32平台的源码。(Used to drive an ink screen of 2.13 inches, an electric paper screen. Contains Arduino, STM32 platform source code.)

本文介绍了一种自适应信号分解新方法-变分模态分解，并且针对滚动轴承早期故障识别困难这一问题，提出了基于VMD的诊断方法。(In this paper, a new adaptive signal decomposition method, variational mode decomposition, is introduced. Aiming at the problem of early fault identification of rolling bearing, a diagnosis method based on VMD is proposed.)

切换系统，分析其稳定性，并采用simulink仿真(Switching system, analyze its stability and simulation using simulink)

说明：  FloTHERM的使用入门手册，写的很好(FloTHERM Introduction Manual, well written)

说明：  用遗传算法计算摄像机自标定参数，论文加上一个MATLAB程序，有详细说明(GA computer SelfCalibrtion paramters of picture，include a matlab program。。。)

CS5460芯片在MSP430单片机中的应用(Application of CS5460 chip in MSP430 single chip microcomputer)

串行加法器的vhdl描述，用两个移位寄存器和一个全加器，一个d触发器实现(The VHDL description of the serial adder, with two shift registers and a full adder, a D trigger)

wsn的一种覆盖方式 利用蚁群算法来优化节点的覆盖面积(WSN coverage of the use of ant colony algorithm to optimize the coverage area of the node )

说明：  使用system verilog编写的一系列代码。包括二进制码与格雷码转换，优先编码器，38解码器，计数器等等(system verilog code with testbench.)

wireless charging source code.