1

随着STM8的停产,新唐的N76E003 pin对pin替换STM8S003F3P6,而且很便宜,故这个时候拿来替换使用再好不过。(With the discontinuation of STM8, N76E003 pin of Xintang replaced STM8S003F3P6 with pin, which was very cheap, so it would be a good time to replace it.)

说明：  矢量网络分析仪的基本原理，内容详细，实用！(Basic Principle of Vector Network Analyser)

制作电子负载，恒压、恒流、恒阻的情况。有原理图、PCB板，可以参考一下。(Make electronic load, constant pressure, constant current, constant resistance. There is a schematic diagram, PCB board, can be referred to.)

说明：  使用DCDC电源驱动步进电机正转和反转，PWM波控制转速(DCDC power supply is used to drive forward and reverse rotation of stepping motor, and PWM wave is used to control speed)

FloTHERM的使用入门手册，写的很好(FloTHERM Introduction Manual, well written)

说明：  提供一个基于瑞昱RTL8382L24口交换芯片的24口+2光口的千兆交换参考设计。包括基于Cadence平台设计的原理图、PCB和RTL8382L、RTL8281B的技术手册。(A Gigabit switching reference design based on 24 + 2 optical ports of Ruiyu RTL8382L24 switch chip is provided. Including the schematic design based on the Cardence platform, PCB and RTL8382L, RTL8281B technical manual.)

说明：  设计并完成了汽车信号灯的控制系统。。。。。(The control system of automobile signal lamp is designed and completed)

说明：  使用system verilog编写的一系列代码。包括二进制码与格雷码转换，优先编码器，38解码器，计数器等等(system verilog code with testbench.)

说明：  基于SIMULINK的dcdc开关电源仿真模型(dcdc converter simulation based on simulink)

A4988步进电机的驱动程序，使用STM32F407单片机驱动(A4988 stepper motor driver)