svm

CDMA程序，包括DS扩频等，个人觉得还不错。(CDMA procedures, including the DS spread spectrum, etc., individuals feel good.)

MATLAB 的一些编程,基本的程序,为出学MATLAB的初学者(MATLAB some programming, the basic procedures for the out of school beginners MATLAB)

Matlab for speech coding encode

The output characteristics of a photovoltaic (PV) array are highly non-linear. Therefore, an accurate andefficient PV model is required to study and analyze the operation of PV system in the changing environ-mental conditions. This paper proposes a precise PV simulator based on the seven-parameter electriccircuit model. The proposed simulator can generate the output characteristics of a PV system preciselyat different operating conditions. It has also enough flexibility to simulate different configurations ofPV panels with series/parallel connections. The robustness of the proposed simulator is demonstratedunder the partial shaded conditions. Additionally, the performance of the developed simulator is verifiedby interfacing it with the actual power electronic converter and maximum power point tracking (MPPT)controller. The proposed PV simulator will facilitate the design aspects of PV systems and help in behaviorassessment of newly developed controllers prior to practical implementation.

阐述了负荷预测的应用研究,用MATLAB实现动态聚类或迭代自组织数据分析，采用了小波去噪的思想，多抽样率信号处理，利用自然梯度算法，预报误差法参数辨识-松弛的思想，进行逐步线性回归，从先验概率中采样，计算权重。( It describes the application of load forecasting, Using MATLAB dynamic clustering or iterative self-organizing data analysis, Using wavelet denoising thought, Multirate signal processing, Use of natural gradient algorithm, Prediction Error Method for Parameter Identification- the idea of relaxation, Stepwise linear regression, Sampling a priori probability, calculate the weight.)

在matlab环境下对ofdm进行仿真的程序(In matlab ofdm simulation under the environment of the procedure)

跳频（占空比为1）2fsk的部分频带干扰误码率计算，这个程序是基于matlab的，自己编的，呵呵(Frequency Hopping (duty cycle 1) 2fsk the partial band interference bit error rate, this procedure is based on matlab, and their series, Oh)

pajek针对复杂网络的仿真 按步骤操作和实践，肯定有很大帮助(pajek simulation for complex network)

tower of henoi problem solving with MATLAB.

无功补偿STATCOM的simulink建模，采用直接电流(STATCOM reactive power compensation Simulink modeling, using direct current)