9806810GS-Algorithm

应用Labview实现远程控制面板的程序。(Labview application to realize remote control panel program. )

基于labview的简单变声程序，简单而有趣，可以尝试一下，并做出改进(Labview program based on a simple change of sound, simple and fun, you can try and make improvements)

通讯控制步进电机的行程，速度，延时及循环次数(Communication controls the travel, speed, delay and cycle times of stepping motors.)

说明：  振动测试分析系统软件包，适用于8.5及以上版本。(failed to translate)

将直角坐标系数据转换成极坐标数据，以便绘制主轴轴心轨迹(Converting Cartesian coordinates into polar coordinates to plot axis center trajectory)

此源程序为用Labview程序编制的，针对采集信号的功率进行分析。。(This source program is compiled by Labview program, and the power of the collected signals is analyzed..)

使用usrp n210,利用Labview实现正弦信号收发，一方面可以利用labview实现实际信号在空中收发，另一方面可以检验设备正常运行。(Using USRP N210 and Labview to transmit and receive sinusoidal signals, on the one hand, it can use LabVIEW to transmit and receive actual signals in the air, on the other hand, it can check the normal operation of the equipment.)

说明：  this code get analog input from myRIO and show its graph

晶体的真空调频设备控制VI，通过串口于西门子PLC的通信。实现现场测量参数返回、控制命令下达、动作参数下达PLC、显示测量结果。(I edit the vacuum device control program, the programming language is LABVIEW, thanks to the example of network gods. Upload this document, hoping to provide help for later generations.)

介绍了Labview编程中的堆栈技术，提供demo案例。(This paper introduces the stack technology in Labview programming and provides demo cases.)