登录
首页 » matlab » ca_cfar1

ca_cfar1

于 2020-03-14 发布
0 282
下载积分: 1 下载次数: 17

代码说明:

说明:  作为雷达信号处理系统的一部分,主要利用快速傅里叶变换(FFT)算法完成雷达回波中各距离单元内运动目标的积累检测,另外还包括恒虚警处理然后提出自适应门限杂波图恒虚警处理器及相干杂波图恒虚警处理器。(As a part of radar signal process system, utilizes FFT to achieve radar reflect wave range unit moving target accumulate detect, in addition including CFAR processThen the adaptive threshold clutter map CFAR processor and coherent clutter map CFAR processor are suggested)

文件列表:

ca_cfar1.m, 3166 , 2020-02-03

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • wavelet2
    小波神经网络2 一共是3个哦(Wavelet neural network 2, a total of 3 Oh)
    2008-06-09 22:08:30下载
    积分:1
  • aeroblk_calibrated
    飞行器空速校正,依据环境的海拔,温度和空气密度(Aircraft calibrated airspeed, altitude based on the environment, temperature, and air density)
    2013-07-18 16:03:38下载
    积分:1
  • ImgCom
    用MATLAB编写的基于多尺度小波分析的图像压缩程序。(Prepared using MATLAB image compression based on multi-scale wavelet analysis.)
    2013-04-27 20:56:35下载
    积分:1
  • Hamming
    说明:  汉明码(Hamming Code)是汉明于1949年的一种能纠正单个错误的线性分组码,最小码距dmin=3。汉明码的实现方式是在原数据中插入m位作为校验位。对于(n,k)汉明码,编码时需满足以下原则(Hamming code is a kind of linear block code which can correct single error in 1949. The minimum code distance Dmin = 3. The implementation of Hamming code is to insert m bit into the original data as check bit. For (n, K) Hamming codes, the following principles should be met)
    2021-04-28 17:48:43下载
    积分:1
  • GPS
    利用Matlab生成GPS C/A 码的基带信号。 (1)产生卫星PRN 号码为“5”的一组C/A 码; (2)循环生成25 页的导航数据,GPS 时间可填入一固定的已知数值; (3)生成C/A 码扩频信号,每个C/A 码码片给出4 个采样数据; (4)基带信号采用方波信号,电平为0 和1,占空比为50 %,不加入噪声,进一步生成某个特定的中频信号。(Matlab generated using GPS C/A code base band signal. (1) generation of satellite PRN number is " 5" a set of C/A code (2) loop generates 25 of the navigation data, GPS time can fill a fixed known value (3) to generate C/A code spread spectrum signal, each C/A code chip gives the four sampling data (4) baseband signals using square wave signal, level 0 and 1, 50 duty cycle, not to join the noise generated further a specific frequency signal.)
    2020-11-29 15:29:29下载
    积分:1
  • diamond3d
    一个用来计算一种钻石形三维的光子晶体的能带结构的程序(A diamond is used to calculate a three-dimensional photonic crystals with the structure of the program)
    2010-11-08 23:07:54下载
    积分:1
  • ber_vs_rx
    MIMO系统误码率随接受天线数目变化而变化,MATLAB仿真程序,源代码(MIMO system bit error rate with the number of antennas to accept changes, MATLAB simulation program, the source code)
    2013-04-22 19:24:50下载
    积分:1
  • Zhang-zhengyou-Camera-calibration
    张正友摄像机标定matlab程序,用来求出摄像机的内外参数矩阵。(Zhang Zhengyou camera calibration matlab procedures used to calculate the camera' s internal and external parameter matrix.)
    2013-11-14 16:10:59下载
    积分:1
  • main
    通过史密斯圆图进行相关计算 求得输入阻抗( Correlation calculation determined by the input impedance Smith chart)
    2015-03-19 16:51:39下载
    积分:1
  • information_shang
    此程序提供两种一维信号信息熵的计算方法,其中一种是近似信息熵计算,可以有效的识别信号的复杂度(This program provides two kinds of one-dimensional signal and the calculation method of information entropy is one kind of approximate entropy calculation, can effectively identify the complexity)
    2020-07-01 03:40:02下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载