NI采集卡多通道采集程序

说明：  LT8619C_LT8618EXB_EVB_HDMI_Converter_20180914_N76E003_PLL_setting_2_Beta

matlab 数据处理 fpga 的sg 程序 类似于DSP的C语言程序 大家分享-they simply Matlab data processing procedures similar to the sg DSP C language program to share with you! !

说明：  基于元胞自动机模拟室内人员疏散的最基本模型(Indoor evacuation simulation based on Cellular Automata.)

for ks0108 LCD Controller

梁可视为平面应力状态，先按图示尺寸划分为均匀的三角形网格，共有8×10＝80个单元，5×ll＝55个节点，坐标轴以及单元与节点的编号如图。将均布载荷分配到各相应节点上，把有约束的节点5l、52、53、54、55视作固定铰链，建立如图所示的离散化计算模型。(The beam can be regarded as a plane stress state. Firstly, the beam is divided into uniform triangular meshes according to the graphic size. There are 8*10=80 elements, 5*ll=55 nodes. The coordinate axis and the numbering of elements and nodes are shown in the figure. The uniform load is distributed to the corresponding nodes, and the constrained nodes 5l, 52, 53, 54 and 55 are regarded as fixed hinges. The discrete calculation model shown in the figure is established.)

说明：  MifareOne Tool(m1卡分析助手) v1.70(MifareOne Tool v1.70)

gps的软件接收机，包括伪码产生，捕获跟踪(gps)

FMCW调频连续波雷达的测距测角，最小均方误差等算法的MSE的计算,小波包分析提取振动信号中的特征频率。( FMCW frequency modulated continuous wave radar range and angular measurements, Minimum mean square error MSE calculation algorithm, Wavelet packet analysis to extract vibration signal characteristic frequency.)

利用图形化界面编写的计算时间的计时器，用3D渲染程序-use graphical interface, the time taken to prepare the timer, 3D rendering process

说明：  用傅里叶逆变换得到的不平度曲线变换的到频率谱曲线与原曲线对比(The frequency spectrum curve of the transformation of the irregularity curve obtained by the trigonometric series method is compared with the original curve)