mcmc1

大规模MIMO信道容量仿真，研究毫米波预编码的可以相互探讨(Massive MIMO capacity)

VPI中基于matlab联合仿真的直接检测ofdm系统(VPI-based co-simulation with matlab for the direct detection ofdm system)

关于nrf24L01的开发设计资料，内含源码分析，可做为设计2.4G无线通信的开发参考(About nrf24L01 development and design information, containing source code analysis can be used as design 2.4G wireless communication development reference)

Phase Modulation and Demodulation(Phase Modulation and demodulation)

ADIBEAM Abstract—the increase in navigation accuracy demanded by EGNOS and Galileo and their future evolution encourages the study and design of advance receiver architectures. In that direction, the ADIBEAM project focuses on the design of high accuracy ground stations, specifically GNSS Reference Stations, in order to improve its robustness in front of multipath and interference errors with the goal of achieving centimeter level tracking accuracy. The adoption of antenna arrays and digital beamforming at the ground reference station receivers is one of the most promising approaches to cope with errors induced by multipath and interference.

matlab对Sato盲均衡算法仿真，仿真图，收敛曲线(Blind equalization Sato)

实现了polar在BEC信道下的编译码，画出了误码率图像(The encoding and decoding of polar in BEC channel is realized, and the bit error rate image is drawn.)

匹配滤波器的实现。主要是通过fft变化使输出自相关最大，在通过滤波器。(Matched filter implementation. Mainly through changes in the output autocorrelation fft the largest through the filter.)

说明：  MATLAB仿真，对比OFDM与F-OFDM性能(Compare F-OFDM with OFDM using MATLAB)

说明：  基于MATLAB语言实现了BPSK、QPSK和QAM在数字通信中的误码率性能，并与理论性能进行了比较。实现了两个发射天线的分集，分析了分集提高误码率性能的原因和实质。(Based on MATLAB language, the BER performance of BPSK, QPSK and QAM in digital communication is realized and compared with the theoretical performance. The diversity of two transmit antennas is realized, and the reason and essence of diversity improving BER performance are analyzed.)