order

SEP matlab code for WSNs clustering

滤波器设计 　　　产生一个连续信号，包含低频，中频，高频分量，对其进行采样，进行频谱分析，分别设计低通，带通，高通滤波器对信号进行滤波处理，观察滤波前后信号的频谱。(The filter is designed to generate a continuous signal containing the low, mid, and high frequency components, to be sampled, for spectral analysis, respectively, to design a low-pass, band-pass filter processing is performed by a high-pass filter on the signal, the spectrum of the signal of the observation before and after filtering.)

Speech Technology: A Practical Introduction Topic: Spectrogram, Cepstrum and Mel-Frequency Analysis Kishore Prahallad Email: skishore@cs.cmu.edu Carnegie Mellon University & International Institute of Information Technology Hyderabad

说明：  线性预测编码（LPC）是主要用于音频信号处理与语音处理中根据线性预测模型的信息用压缩形式表示数字语音信号谱包络（en:spectral envelope）的工具。它是最有效的语音分析技术之一，也是低位速下编码方法高质量语音最有用的方法之一，它能够提供非常精确的语音参数预测。(linear predictive coding)

说明：  源程序中包含PCMu率与PCM线形之间的编解码(source contains PCMu rate between the linear PCM codec)

This is file to compress Audio using CVSD at 16 Kbps

双通道语音增强算法，消除环境噪声。采用归一化自适应方法，噪噪声抵消10dB，语音保持较好可懂度。(The dual-channel speech enhancement algorithm to eliminate ambient noise. Using normalized adaptive noise noise offset by 10dB, and the voice to maintain good intelligibility.)

quatization of audio signal and plot the signal after quantization

TXT信号的获取：一般都是拿到一个.WAV的信号，用cooledit或者其他的打开，另存为txt格式，注意的是，此时txt文件的前面两行会写入一些采样率的信息，将这几行删掉，程序就可以顺利得读取你保存的txt了。(TXT signal acquisition: generally get a .WAV signal, with coolit or other open, save as txt format, note that at this time txt file in front of two lines will write some sampling rate information, will These lines deleted, the program can be smooth to read your saved txt.)

迁移学习程序，适用于NLP问题，大家可以看看。(To migrate learning program suitable for NLP problems)