温度监控报警系统

这是16QAM的仿真，带GUI界面，很好用的。(This is 16QAM simulation, with GUI interface, very useful.)

本程序分析了MIMO系统中发射天线数目对系统容量的影响(This program analyzes the MIMO system, the number of transmit antennas of the system capacity,)

这是一个关于gmsk和msk性能分析比较的源程序，能很好的实现GMSK频谱和功率谱。(this a matlab program about gmsk and msk s dpinpu and gonglvpu.)

说明：  最大限度地平 FIR 逼近 （拉格朗日插值法） 拉格朗日插值是一种时域方法，导致基于多项式的筛选器的一个特殊情况。用 M 次多项式近似表示输出信号。最简单的情况 (M = 1) 对应于线性插值。让我们设计和分析将通过各种馏分拆分单元延迟的几种线性分数时滞滤波器：(Maximally-Flat FIR Approximation (Lagrange Interpolation) Lagrange interpolation is a time-domain approach that leads to a special case of polynomial-based filters. The output signal is approximated with a polynomial of degree M. The simplest case (M=1) corresponds to linear interpolation. Let's design and analyze several linear fractional delay filters that will split the unit delay by various fractions:)

一个事件提醒程序,类似于手机中的事件提醒(An event to remind the procedure, similar to events in the mobile phone to remind)

说明：  在matlab环境下,仿真基于循环平稳特征检测的频谱感知,(Spectral sensing based on cyclic stationary feature detection)

说明：  turbo码的c语言程序，使用c语言来完成整个turbo码的编解码过程，并且程序后附带比较详细的解释(turbo code c language program, use c language to complete the entire turbo code codec process and procedures attached to explain it in more detail)

适用于VS2010以后的版本对串口进行读取数据和写入数据到串口。(Applicable to VS2010 and later versions to read data and write data to the serial port.)

说明：  简单的时延波束形成算法，实现简单，并画出指向性图(Simple delay beamforming algorithm)

MODBUS RTU using Attiny44 from Atmel