FloEMC_Flotherm

文件中包含stm32开发板所配套的开关使用说明的程序例程，重在讲解开关是如何被使用的，在kEIL5软件上怎么编写的。(The document contains the program routine of the switch instructions matched by STM32 development board, focusing on how the switch is used and how to write on kEIL5 software.)

资源描述spi 测试接口，用来读写寄存器，经过实际测试，可以正确读写。

说明：  包含主板，驱动板，运放等所需全部板工程文件(Contains all board engineering files required for motherboard, driver board, op amp, etc.)

矢量网络分析仪的基本原理，内容详细，实用！(Basic Principle of Vector Network Analyser)

通过IO口控制两路24V电压输出，一路24V转两路24V(Two 24V voltage outputs are controlled by IO port, one 24V is converted to two 24V.)

串行加法器的vhdl描述，用两个移位寄存器和一个全加器，一个d触发器实现(The VHDL description of the serial adder, with two shift registers and a full adder, a D trigger)

ldpc的算法介绍及其fpga上硬件实现(Introduction of LDPC algorithm and Its FPGA implementation)

说明：  ATSHA204A加密芯片详细使用方法！ 保护您的程序不被抄袭。(ATSHA204A encryption chip detailed use method! Protect your program from plagiarism.)

rtl8370单芯片8口千兆交换机原理图(Rtl8370 single chip 8 gigabit switch schematic diagram)

说明：  基于FPGA的任意波形发生器DDS,verilog编写，正常使用(Arbitrary waveform generator DDS based on FPGA)