368255-2-connector

msp430 for ov7670 驱动(msp430 for ov7670 drive)

AT89S51的串口程序，可以直接编译使用，标准程序(AT89S51 serial procedures, the compiler can directly use standard procedures)

51单片机SCMrtoss源代码，非常好用的能够移植 (51 the microcontroller SCMrtoss source code, very useful to be able to transplant)

基于TI的MSP430处理器控制CC1100-CC2500射频芯片的代码，包括发送和接受端，使用IAR开发环境。(Based on TI' s MSP430 processor controlled radio frequency chip CC1100-CC2500 code, including the sending and the receiving end, the use of IAR development environment.)

51单片机详细资料，包括数码管、AD/DA转换,I2C，定时器等等(51-Single chip machine)

光电编码器，是一种通过光电转换将输出轴上的机械几何位移量转换成脉冲或数字量的传感器。 这是目前应用最多的传感器，光电编码器是由光栅盘和光电检测装置组成。光栅盘是在一定直径的圆板上等分地开通若干个长方形孔。由于光电码盘与电动机同轴，电动机旋转时，光栅盘与电动机同速旋转，经发光二极管等电子元件组成的检测装置检测输出若干脉冲信号(Photoelectric encoder, a photoelectric conversion to the output shaft of the mechanical geometry of displacement into a pulse or digital sensors. This is currently the most widely used sensors, optical encoder is determined by the grating disk and photoelectric detection device component. Grating disc is a circular plate in such a diameter of several rectangular holes partially opened. Because coaxial photoelectric encoder and the motor, the motor rotates, the grating disk rotates with the same speed motor, the light-emitting diodes and other electronic components of the detection device detects certain pulse signal output)

USB鼠标的设计资料之二：原理图。PDF和DSN格式(USB mouse design data 2: Schematic diagram. PDF and DSN format)

基于STM32F107VE 单片机的CAN1与CAN2的收发通讯基础例程。(STM32F107VE microcontroller based on CAN1 and CAN2 transceiver communication basic routines.)

步进电机解码红外控制，能够实现红外与步进电机完美控制！(Stepper motor control decoding Infrared, Infrared and stepper motor to achieve perfect control!)

基于stm32的电子时钟的设计，四个按键控制(Based on stm32 electronic clock design, four key controls)