wilson

一篇关于matlab在热传导领域的应用文献。(A literature matlab in the field of thermal conduction.)

网上复制了一个BP预测的程序自己改了一下，效果不是很好。 P 和T都是往期的数据(Online copy of a program his BP forecast changed a bit, the effect is not very good. P and T are the data to the period)

simulink双效串并联吸收式制冷动态仿真(simulation for absorption refrigeration)

说明：  非常全面的灵敏度分析讲解以及灵敏度检验案例(Very comprehensive explanation of sensitivity analysis and sensitivity test cases)

产生BPSK调制信号，通过高斯信道，接收端解调，计算误码率(BPSK modulated signals generated by Gaussian channel, the receiver demodulation, bit error rate calculation)

Matlab files of chapter 3 kalman filtering 3 edition of grewal

本人搭建的Matlab风电模型、直驱2MW的，研究塔架振动的(I set up the Matlab, 2 mw direct-drive wind model, the mode of vibration，PMSG)

以两个麦克风线性阵列为例通过相关函数进行音源定位，定位范围为0到180度(Case of two microphone linear array sound source through the relevant function location, location range from 0 to 180 degrees)

由设计要求可知，wp<=0.2π，允许误差幅度小于1dB，ws>=0.3π内衰减应大于15dB。为了验证数字滤波器的实际滤波功能，设计程序时，把输入序列定为验证函数x（t）=4sin（100πt）以及x（t）=4sin（200πt）和x（t）=4sin（400πt）。又因为Ts=1.25ms，T=80ms，故采样点为64，即N=64，所以当M=6，可以同时调试并验证程序的滤波功能。(Seen by the design requirements, wp < = 0.2π, allow a margin of error of less than 1dB, ws> = 0.3π within attenuation greater than 15dB. In order to verify the actual filtering function of the digital filter design program, the input sequence as validation function x (t) = 4sin (100πt) and x (t) = 4sin (200πt) and x (t) = 4sin (400πt) . And because Ts = 1.25ms, T = 80ms, so the sampling points is 64, that is N = 64, so when M = 6, can debug and validate filtering program.)

artifical bee colony algorithm