C-S

双椭球焊接子程序，用于ABAQUS焊接调用(Welding subroutine, in order to facilitate ABAQUS simulation welding seam.)

说明：  摄像头 低压低噪马达驱动--MS41908(Camera Low Voltage and Low Noise Motor Drive--MS41908)

在powerbuilder下实现flash界面, 在powerbuilder下实现flash界面-PowerBuilder realize in the next flash interface flash interface under PowerBuilder

DSP TMS320vc5416 FFT代码-DSP TMS320vc5416 FFT code

易语言 超好看的皮肤 喜欢就拿去吧-Easy language like super good-looking skin Take the Go

说明：  主要计算了轮轨接触2D算法，是很好的一个程序 简单明了(The 2D algorithm for wheel rail contact is mainly calculated It's a good program to be simple and clear)

opencv icon matching

说明：  PC，相位一致性，MATLAB程序，自带主程序(PC, phase consistency, MATLAB program, with the main program)

一款很好的源码，非常的好用，亲测哦，欢迎大家一起来好好的体验一下吧(A very good source code, very useful, personally tested oh, welcome to come together and have a good experience)

说明：  设计一个挂载在 APB 总线上的计数器，按照 APB 的时序给计数器赋值，主 机通过地址对计数器进行配置，通过数据输入端口给计数器设置计数器最大值， 并通过数据输出端口输出计数器的计数值。该设计还设置了一个计数完成信号， 当计数器满足模式配置后的计数要求时，会将该信号拉高(A counter mounted on the APB bus is designed. The counter is assigned according to the sequence of APB The computer configures the counter through the address and sets the maximum value of the counter through the data input port, And output the count value of the counter through the data output port. The design also sets a count completion signal, When the counter meets the counting requirements after the mode configuration, the signal will be pulled high)