PID程序 - 副本

说明：  智能车辆纵向动力学模型建模及控制系统设计(automation control)

通过GPIO口，模拟I2C协议，和设备进行I2C通信(I2C communications via GPIO ports, analog I2C protocol, and equipment)

ATMEG128单片机开发板上自带的LED点阵源程序，给大家分享一下(ATMEG128 microcontroller development board comes with the LED dot matrix source, to share with you)

基于T6963C控制芯片的160_128液晶程序(This is for lcd s code!)

STM32平台下使用LTC2400来采样数值，采取SPI的进行通讯。(By using the STM32 platform，use LTC2400 to sample values, use the SPI communication.)

基于SRM32F407实现了FLASH模拟EEPROM实验(Realization of FLASH simulation EEPROM experiment based on SRM 32F407)

51单片机AT89C52串行通信.上位机通过串口向单片机发数据，单片机接收后发回给上位机。(51 AT89C52 single-chip serial communication. PC send data through the serial port to the microcontroller, the microcontroller has sent back to the host computer.)

PC通过串口控制Zigbee温度传感器的采集启动与停止。。。(PC controls the start and stop of Zigbee temperature sensor acquisition through serial port.)

基于STM32F103战舰版的RC522程序(RC522 program based on STM32F103 warship Edition)

This source code provides a tool to convert .hex files cyrpess programs to uploadable cyacd programs. These programs can then be sent to a cypress development board. It can be compiled under Linux.