Desktop

单级倒立摆LQR控制仿真 降维状态观测器的两种设计方法及算例(Inverted Pendulum Simulation Reduced LQR control of two state observer design method and examples)

在matlab中可以调用的程序，用c语言编写，cuda求直方图(used in caculating histogram of color images , )

Experiments with MATLAB源代码：fern仿真(Experiments with MATLAB source code: fern Simulation)

基于MATLAB的，电能质量分析中用来检测谐波的闪变仪simulink仿真设计模型(Based on MATLAB, power quality analysis for detecting harmonics flickermeter simulink simulation model design)

经典中文天线书籍，《天线理论基础》任朗，浅显易懂()

数模中的钻井问题的matlab源码，需要的下！(few Die drilling Matlab source of the problem, it needs under!)

LPC program example

用MATLAB程序软件完成Z-N法对控制器的参数整定，实现P,PI,PID控制器的分别参数整定，并求出控制器的控制参数Kp，Ti，Td。最后绘制出不同控制器控制下的及参数整定前后的单位阶跃响应图进行比较。(MATLAB program software is used to complete the parameter tuning of the controller by Z-N method. The parameters of P, PI, PID controller are adjusted, and the control parameters of the controller Kp, Ti, Td are obtained. Finally, the unit step response diagram before and after parameter tuning is plotted under different controller control.)

he mpdecoder project provides an MATLAB class mpdecoder that allows doing message passing (MP) decoding of binary LDPC codes. The MATLAB class mpdecoder actually calls the C++ class MPDecoder through the MATLAB MEX interface, which ensures its high decoding speed.

本文档介绍了关于信道仿真的一些程序代码和一些仿真结果，并对各种信道仿真结果做了比较和分析(This document describes a number of channel simulation program code and some simulation results, and a variety of channel simulation result of the comparison and analysis)