space_vectort

首先根据短训练字的特性进行相关运算，进行信号到达检测，当检测到相关值大于门限一定次数后，认为有信号到达。然后根据长训练字的特性，进行相关运算，进行OFDM符号FFT窗口起始位置的估计。估计出FFT窗口的位置后，先在时域进行小频偏的估计，将两个长训练字进行小频偏补偿后，进行FFT运算，根据FFT运算的结果进行整数倍频偏的估计。这些参数估计完成后，就可以进行数据解调了。先对数据部分进行完整的频偏补偿，然后根据估计的FFT窗口位置进行FFT运算得到频域的数据，进行解调。然后在对应于导频的子载波位置上提取出导频信息，根据导频信息估计出剩余定时误差以及剩余的信道响应误差，将误差量送入环路进行跟踪。当收到所有数据后，重新回到信号到达检测状态，进行下一次信号到达的检测和信号接收。(First, according to the characteristics of the short training word correlation operation, the signal reaching the detector, when the detected correlation value is greater than the threshold after a certain number of times that a signal arrives. And then the characteristics of long training word, the correlation operation for the FFT window starting position of an OFDM symbol estimate. The estimated position of the FFT window, the first small frequency offset in the time domain estimation, the two long training word small frequency offset compensation, the FFT operation, the FFT result of the operation for integer frequency offset estimate. These parameter estimation is completed, the data can be demodulated on. The first portion of the data for a complete frequency offset compensation, and based on the estimated FFT window position of the FFT operation to obtain frequency domain data, demodulated. Then corresponding to the position of the pilot subcarriers are extracted on pilot inform)

绘制二维非线性系统的相图，MATLAB程序，自已编写，多多交流！(Phase diagram, drawing two-dimensional nonlinear system MATLAB program, written, more exchanges!)

emd和eemd可用于信号去噪，提取瞬时频率。(emd and can be used to signal de-noising eemd extracting instantaneous frequency.)

数值分析国外教材源代码 Atkinson Matlab (Atkinson Matlab )

Parameterized modules in Erlang

SER of 4-PAM modulation

This is uniform quantization coded in matlab

用于消噪处理用于研究Mallet算法及滤波器设计分解的高频系数采用db9较好,即它的消失矩较大(for Signal Processing Algorithms for the study Mallet decomposition and filter design using high-frequency coefficients db9 better, that is, its larger vanishing moments)

src 算法中的迭代算法,通过该算法可以计算SRC的参数，通过使用线性表示来求。(src algorithm iterative algorithm, the algorithm can be calculated by the SRC parameter, by using a linear representation requirements.)

root locus-matlab control project