matlab读取矢量文件

原创：用matlab仿真bch算法，经过调试可以正常运行(originality : BCH Matlab simulation algorithms, can debug uptime)

16个入射信号，64位天线阵元圆阵的加权波束方向赋形(Weighted beam direction shaping of 16 incident signals and 64 bit array elements)

三相永磁同步电机双闭环调速控制系统的设计，基于矢量svpwm控制。供大家参考。(Phase permanent magnet synchronous motor dual loop speed control system design, vector-based svpwm control. For your reference.)

MIMO信道容量分析,分析不同信噪比情况下信道容量的变化及收发天线数的变化对信道容量的影响。(Ergodic Capacity of MIMO system)

说明：  fdtd 时域有限差分法pml吸收边界条件 实现(fdtd FDTD method achieved pml absorbing boundary condition)

绘制应力场云图，其中还提供了一个解释如何调用程序的文件(plot stress field contour)

永磁风力发电 最大功率跟踪 仿真程序(The permanent wind power maximum power tracking simulation program)

qpsk信号插入导频，使用升余弦滤波器，利用导频估计信道，在simulink中仿真(inset pilot in QPSK signal, use square root raised cosine filters in simulink)

可以方便的进行算例分析，IEEE case300(It is convenient to carry out an example analysis)

三相SVPWMmatlab仿真模型，需要提醒同志们的是，在仿真之前必须build一下s-function builder，不然无法运行模块，采用s-builder的原因是建成的模块很简洁，而且运行速度要比其他方法快的多(The three-phase SVPWMmatlab simulation model, the need to remind Comrades is, before the simulation must be build S-function builder, or can not be run by s-builder module, the reason is built module is very simple, and the speed is much faster than other methods)