Wind_Field_Process

A、名称：限幅滤波法（又称程序判断滤波法） B、方法： 根据经验判断，确定两次采样允许的最大偏差值（设为A）， 每次检测到新值时判断： 如果本次值与上次值之差<=A，则本次值有效， 如果本次值与上次值之差>A，则本次值无效，放弃本次值，用上次值代替本次值。 C、优点： 能有效克服因偶然因素引起的脉冲干扰。 D、缺点： 无法抑制那种周期性的干扰。 平滑度差。(A. Name: Limited filter method (also known as program judgement filter method) B. Method: Based on experience, the maximum allowable deviation (set to A) of two sampling times is determined. Judge each time a new value is detected: If the difference between the current value and the previous value is <=A, the current value is valid. If the difference between the current value and the previous value is greater than A, then the current value is invalid, abandon the current value and replace the current value with the last value. C. Advantages: It can effectively overcome the impulse interference caused by accidental factors. D. Disadvantages: That periodic interference cannot be suppressed. The smoothness is poor.)

光伏控制器，自动充放电控制12V/10A光伏控制器（ERA-04-10-A）： 额定工作电压：DC12V 最大充电电流：10A 最大放电电流：5A/路（共两路负载） 太阳能组件开路电压：25V 空载电流：<15mA 温度补偿：-20Mv/°C 工作环境温度：-25°C～+50°C 使用海拔：<5500M 控制器尺寸（mm）: 光控电压（25°C）：<=3.3V 过放保护电压（25°C）：<10.8V 过放恢复电压（25°C）：>10.8V 过充保护电压（25°C）：>15.0V 过压保护电压：17.68V 过压恢复电压：14.7V 浮充电压（25°C）：13.4V～13.7V 恢复正常充电电压（25°C）：13.2V 结束正常充电电压（25°C）：15.0V (PV controller, automatic charge and discharge control 12V/10A PV controller (ERA-04-10-A): Rated voltage: DC12V Maximum charge current: 10A Maximum discharge current: 5A/Road (a total of two loads) Solar components of the open circuit voltage: 25V No-load current: < 15mA Temperature Compensation:-20Mv/° C Operating Temperature:-25 ° C ~+50 ° C with elevation: < 5500M Controller Size (mm): light control voltage (25 ° C): < = 3.3V over-discharge protection voltage (25 ° C): < 10.8V over-discharge recovery voltage (25 ° C):> 10.8V overcharge protection voltage (25 ° C):> 15.0V over-voltage protection Voltage: 17.68V overvoltage recovery voltage: 14.7V float voltage (25 ° C): 13.4V ~ 13.7V back to normal charging voltage (25 ° C): 13.2V end of the normal charging voltage (25 ° C): 15.0V)

说明：  计算散度涡度等气象要素，还有计算很多诊断量的程序(canculate divergence and vorticity)

6205滚动轴承的内圈故障仿真出的故障信号(rolling bear signal)

这是分别基于两电平SVPWM和三电平SVPWM的PMSM矢量控制模型，对初学者比较实用，采用matlab2012以上版本打开！(This is based on two level SVPWM and three level SVPWM PMSM vector control model, more practical for beginners! Use matlab2012 or more to open.)

一个三相异步电动机（感应电机）设计程序，用来实现电动机设计及其相关的设计计算(A three-phase asynchronous motor (induction motor) design process, used for motor design and its related design calculation)

说明：  全屏幕对比查看图像 支持鼠标放大、缩小和平移； 支持键盘移动。(Full screen contrast view image Support mouse zoom in, zoom out and pan; Keyboard movement is supported.)

激光雷达点云数据拟合点云拟合icp算法(Point cloud fitting ICP algorithm for LIDAR point cloud data)

水库调度应用,水库水文信息快速准确统计，实现制表自动化(Application of reservoir operation, Hydrological information fast and accurate statistics, the realization of automated tabulation)

使用CW方程，使用最小能量，采用脉冲推力，实现在一天内两航天器的交会对接。本质上就是一个交会轨道优化问题，由给定的条件优化选取设计变量，使目标函数得到最优值。(Using the CW equation, use the minimum energy, the use of pulse thrust, to achieve in a day two spacecraft rendezvous and docking. Is essentially an intersection orbit optimization problem, by the given conditions to optimize the selection of design variables, so that the objective function to get the optimal value.)