sci_tool-master

说明：  串口通讯实验： 本实验得到的结果为，打开超级终端，设置波特率为115200，数据流控制位为无。运行系统，就会显示“UART & Interrupt Experiment,Please Input from the keyboard”，我们就可以通过写串口操作。 在flash调试时，需要修改RO BASE为0x00000000，其他不用修改，重新编译下载就可运行。 注意：由于系统产生中断，程序计数器就会跳到0x18处执行中断服务子程序，所以不能在SDRAM调试。 (Serial communication experiment: the results of this experiment, open HyperTerminal, set the baud rate to 115200, data flow control bit is not. Operating system, it will display &quot UART &amp Interrupt Experiment, Please Input from the keyboard&quot , we can write the serial port operation. Debug in flash, you need to modify the RO BASE is 0x00000000, the other not modify, recompile download can run. Note: Due to system interrupt, the program counter will jump to 0x18 Department execute the interrupt service routine, it can not debug the SDRAM.)

初始化RTCM控制，并且把文件或者串口数据转输出成RTCM格式(RTCM control initialization, and the output files or serial data transfer format to RTCM)

云台控制的C++详细源码，二次开发可以直接用。(The PTZ control C++ detailed source, secondary development can be directly used.)

STM32+LWIP的串口转网口程序源码(STM32+ LWIP switch network serial port source code)

瑞萨单品机9222，串口通信历程及寄存器介绍(nec 9222 MCU，uart communication and register s introduce)

该源码为平时所用的串口调试工具的源码，效果还是挺不错的(The source is usually used for serial debugging tools, source code, the effect is very good)

使用vc++开发的云台镜头控制系统，主要通过串口实现控制，已编译通过，可学习使用(PTZ camera control system)

此程序为常用通讯子程序，已调试通过 可以直接应用(this procedure commonly used for communications subroutine, debugging through direct application)

针对于Win8.1的串口调试助手（WPfban）(Serialport win8.1)

串口打印指令源码，例程程序结合易语言扩展界面支持库，使用端口发送打印指令。(Serial print command source, combined with easy language extensions routine program interface support library, using the port to send print commands.)