powerflow33

轴系扭转振动的matlab计算,将采集的脉冲信号转化成扭转角。(torsional vibration)

微电网，6节点的电网数据，包括风力，负荷，发电机输出功率，节点图等信息，可参考(Microgrid, 6-node grid data, including wind power, load, generator output power, node diagram and other information, can be referred to.)

说明：  这是一个PSCAD4.2.1的火电机组模型，容量是660MW。(This is a PSCAD 4.2.1 thermal power unit model with a capacity of 660MW.)

风机模型，自改风机模型单双馈模型pscad对微网的构成一部分，用来对事物进行控制参数优选用了好久了(Fan model, self changing fan model, single and double fed model PSCAD part of the microgrid constitute a part of the control parameters that have been selected for a long time.)

热电联供系统多能流建模，采用扩展牛顿—拉夫逊算法分解求解的方法进行计算。(The multi-energy flow model of cogeneration system is established, and the extended Newton-Raphson decomposition method is used to calculate the multi-energy flow.)

说明：  用于fluent的二维UDF，主要用于求解VOF模型体积分数梯度，进而输出毛细管力参数(UDF of two-dimensional capillary force with VOF)

说明：  最小成本目标函数条件下，进行电力系统优化潮流计算，约束包括最大最小出力、网络约束、爬坡约束等。(a power system optimized calculation program is performed under the condition of minimum cost objective function, and the constraints include maximum and minimum output, network constraints and climbing constraints.)

说明：  程序能够完成三相不对称的潮流计算和故障计算(This can complete three-phase power flow calculation and fault calculation)

说明：  本程序可以建立算法来形成节点阻抗矩阵,利用节点阻抗矩阵来计算短路故障情况下的节点电压和线路电流，程序可供电力系统编程参考。(This program can establish an algorithm to form the node impedance matrix, and use the node impedance matrix to calculate the node voltage and line current in the case of short circuit fault. The program can be used as a reference for power system programming.)

已知压气机的状态参数可求解出该状态下的特性线(if the state of compressor had been knowed,the code is used to calculate the charcter line)