LDPC参考

bpsk 调制 使用的是matlab(bpsk modulation)

说明：  基于matlab实现OFDM，调制方式为QPSK，可以对信道的状态进行估计(OFDM is realized based on MATLAB, the modulation mode is QPSK, and the channel state can be estimated)

说明：  脉冲压缩的匹配滤波。目标距离分别为10米，30米和100米，对于未压缩的脉冲，三个回波信号混叠在一起，不能分辨，而经过脉冲压缩的脉冲信号则可通过匹配滤波收到3个回波信号(Matched filtering for pulse compression.Target distances are 10 metres, 30 metres and 100 metres, respectively. For uncompressed pulses,The three echo signals are overlapped and can not be distinguished. While pulse compression can distinguish three echo signals after matched filtering)

不同模态OAM的相位图，电场场强图，及用箭头表示相位变化(Phase diagrams, electric field intensity maps of different modes of OAM, and phase changes with arrows.)

simulink for BPSK modulation

该工程实现对单载波系统QPSK的频偏估计算法。调相信号在接收机相干解调时需要同频同相的参考载波，而发射机和接收机之间往往存在频率偏差，为了消除这种误差，必须在软件层面实现。使用了QPSK四相调制的信号特点进行载波频偏估计，经验证，效果较好。(This project implements frequency offset estimation algorithm for single carrier system QPSK. The phase modulation signal needs the same frequency reference carrier in the coherent demodulation of the receiver, and the frequency deviation often exists between the transmitter and the receiver. In order to eliminate this error, it must be implemented on the software level. The carrier frequency offset estimation is carried out by using the signal characteristics of QPSK four phase modulation.)

基于QR分解的宽度优先球形译码，即通常所说的K-best算法，适用于MIMO技术中的接收端信号检测。(Priority sphere decoding based on the width of the QR decomposition, commonly known as the K-best algorithm for the receiver signal detection in MIMO technology.)

在多周期CPU的基础上设计一个前导0检测程序。(A preamble 0 detection program is designed on the basis of multi period CPU.)

采用BPSK调制技术，用ZF和ZF加并行干扰消除的方法检测系统的误码率。(Using BPSK modulation technique, with the ZF and ZF plus parallel interference cancellation method to detect the BER.)

利用3GPP交织器和LTE交织器完成turbo码的仿真并做比较，不同解码算法的比较(Using 3GPP Interleaver and complete LTE interleaver turbo code simulation and comparison, a comparison of different decoding algorithms)