Eugene_Hecht_optics_ebook_and_solution

Keil C51 的使用说明,详尽介绍了Keil C51 的操作.(Keil C51 use, the details of the operation Keil C51.)

DS18B20多IO驱动，带有滤波，数据更稳定精确(DS18B20 driver, with filtering, more stable and accurate data)

本作品是基于stm32检测温湿度，可以通过串口观察实时状态。(This work is based on stm32 detection temperature and humidity, you can observe the real-time status through the serial port.)

说明：  一个arm开发板的sd卡程序设计用于设计SD卡的实现(An arm development board designed sd card program is designed for the realization of SD card)

基于cortex M3的IIc24C02读写数据，在群星系列单片机上验证通过！(Cortex M3 based on the IIc24C02 read and write data to validate the Stars Series MCU through!)

单片机在电冰箱智能模糊控制中的应用(SCM in refrigerators Intelligent Fuzzy Control System)

绪论，介绍了温度控制的发展趋势，发展现状，以及PID控制的相关介绍(the introduction of an article)

51单片机占空比调速或调光程序，仿真通过，里面有全部程序包括仿真文件(51 microcontroller duty cycle governor or dimming program, through simulation, which all procedures including simulation files)

基于pic16f676 EEPROM的问题 用软件仿真没问题，但烧到片子里，不能正常运行。情况是这样的：假如循环向EEPROM中写数据，9，8，7，6，5，4，3，2，1，然后读，发现每一位读出的都一样，是写循环中第一个写进去的字节，也就是9。其他的并没有写进去。 EEPROM的写通过判断标志位就可以，但是在下一次写之前要清除上一次写完成的标志位。也就是说，每次写完要清除完成标志位，否则下一次写不进去。(Based on pic16f676 EEPROM problem With the software simulation no problem, but burn to film, not normal operation. The fact of the matter is: if cycle to write the data of EEPROM, 9,8,7,6,5,4,3,2,1, then read, and found that each of the read, write the first cycle is written in bytes, also is 9. The other are not written in. Write through the judgement of EEPROM sign a can, but in the next write to remove the last completed before writing the sign of a. That is, every time to remove the written finish marks a, or the next write in. )

实现普通交通等的控制，使用超声波增加了车流量的检测(To achieve the control of general traffic, the use of ultrasound increases the detection of traffic flow.)