jakeschannel

说明：  雷达动目标检测仿真，含脉冲压缩，mtd处理等(Radar moving target detection simulation, including pulse compression, mtd processing, etc.)

说明：  基于matlab实现OFDM，调制方式为QPSK，可以对信道的状态进行估计(OFDM is realized based on MATLAB, the modulation mode is QPSK, and the channel state can be estimated)

基于Q学习实现自主选频与动态频谱接入，认知无线电(Dynamic spectrum access with Q-Learing)

16位CRC校验原理与算法分析，很详尽，学习CRC16的重要资料。(16-bit CRC checksum algorithm theory and analysis, very detailed and important information to learn CRC16.)

说明：  基于quartus的布斯乘法器的verilog 实现。布斯乘法算法是计算机中一种利用数的2的补码形式来计算乘法的算法。该算法由安德鲁·唐纳德·布斯于1950 年发明，当时他在伦敦大学伯克贝克学院做晶体学研究。布斯曾使用过台式计算器，由于用这种计算器来做移位计算比加法快，他发明了该算法来加快计算速度。(The verilog codes of booth multiplier based on quartus. Booth multiplication algorithm is a computer algorithm using the complement form of number 2 to calculate the multiplication. The algorithm was invented in 1950 by Andrew Donald booth, who was working on crystallography at birkbeck college, university of London. Booth used a desktop calculator, and because it was faster to do shifts than to add, he invented the algorithm to speed up the calculations.)

D2D通信matlab仿真，基于matlab的D2D设备到设备通信系统模型仿真(Simulation of D2D Communication with MATLAB)

ＯＦＤＭ程序　波形如下 子载波数 128 ％ 位数/ 符号 2 ％ 符号数/ 载波 100 ％ 训练符号数 0 ％ 循环前缀长度 8 (1/16)*T ％ 调制方式 4-QAM ％ 多径信道数 3 ％IFFT Size 128 ％ 信道最大时延 2(OFDM waveform procedures following subcarriers median number of 128%/2% Symbol Symbol/Carrier 100% Training a few symbols 0% cyclic prefix length 8 (1/16)* T% modulation 4-QAM% multi-path channel number 3% IFFT Size 128% maximum delay Channel 2)

This m file models a DPSK UWB system using a delay in one leg

该程序实现水声信道的模拟方法及性能分析，提出了一种信的水声信道模型(The program implements underwater acoustic channel simulation methods and performance analysis, presents a letter of underwater acoustic channel model)

M-PSk(M=2,4,8)-grayencoded, in AWGN channel,plot BER and SER, compare it with theorical results